Specific Features of the Russian Black Sea Coast Dynamics and Morphology (Kerch Strait?Psou River Mouth)
The general contour of the Russian Black sea Coast was formed during the last transgression. Definite dependence can be treated between the modern coastline configuration and transformations...
Specific Features of Shoreline Development in Sochi Region and Engineering Methods of Coast Protection
A coast segment from Tuapse City to the Psou River, 113 km long, is extended in this paper. Geological description of the coast has been made, and approximate values of the abrasion rate...
The Flows of Suspended Sandy Material Along the Section of Bulgarian Coast
Combining of available models of elementary hydro- and lithodynamic processes in a single calculation scheme permits to evaluate the volumes of detrital material transported either way...
About Some Dynamic Conditions of the Beach Sedimentary Strata Formation on the Bulgarian Sandy Coast of the Black Sea
Based on detailed studying of the beach sedimentary sequence composition in sections of perpendicular trenches in the western (Bulgarian) coast of the Black sea and comparison with results...
Disposal of Dredged Material from the Estuaries
The silting up of harbours and the lower parts of rivers are serious problems. These problems can be characterized in terms of quantity and quality. Two separated cases are described....
Aquatic Disposal of Dredged Material in the Belgian Part of the North Sea
Extensive research and study on the behaviour of dredged material after dumping in the sea has been conducted on the disposal grounds S1 S2 and Zb Oost located in the southern Bight of...
CANUSLANT?An Evolving-Marine Pollution Contingency Plan
The progress of CANUSLANT exercises to data is addressed in this paper. This exercise model can be used to initiate or improve Marine Pollution Contingency planning....
Dynamic Perspective on the Capillary Barrier Effect at the Interface of an Upper Fine Layer with a Lower Coarse Layer
The theoretical principles behind the determination of infiltration rate into a coarse layer overlain by a tight layer are reviewed. As a descending unsaturated wetting front hits the...
Kinematic Mixing in Stratified Aquifers
The mixing process in heterogeneous aquifers is presented as the bending and stretching of material lines. A linear mixing efficiency is defined in terms of the mean values of a unit length...
Application of a Density-Dependent Flow and Transport Model to a Coastal Aquifer System
A three-dimensional density-dependent groundwater flow and solute transport model for a coastal region in east-central Florida is presented. The model covers an area of approximately 2900...
Polyacrylamide Decreases Furrow Erosion
Erosion from furrow irrigated land is a serious problem in southern Idaho and several other areas. Polyacrylamide, a very long chain polymer, increases aggregate stability and flocculates...
A New Look at the Potential of Hygroscopic Seeding in Summertime Convective Clouds
Hygroscopic seeding was conducted in the sixties and early seventies in the USA, but since then, most cloud seeding efforts have used glaciogenic seeding materials, usually silver iodide...
IRRICAD ? Computerized Irrigation Design
IRRICAD is a software program that helps irrigation designers by using a computerized systems approach to design. The program features drawing CAD input, interpolation of elevation data,...
Density Fluctuations and Use of the Krypton Hygrometer in Surface Flux Measurements
The magnitude of the of the Webb et al. (1980) density corrections on water vapor fluxes due to the flux of sensible heat is examined in terms of the Bowen ratio. The correction due to...
Soil Bulk Density Sampling for Neutron Gauge Calibration
The ASCE Task Committee on Neutron Gauge Calibration met in Logan, Utah in July 1992 to investigate the various methods of soil sampling, installation of access tubes, effect of various...
Measuring Soil Bulk Density Profiles with a Single Probe Gamma Density Gauge
Calibrating neutron depth gauges for measuring soil water content profiles requires soil bulk density data. In this study, the feasibility of using a single probe gamma density gauge to...
Error Analysis of Bulk Density Measurements for Neutron Moisture Gauge Calibration
Six bulk density sampling methods were evaluated for use in neutron gauge calibration. All six methods provided estimates of bulk density which were generally within 5% of bulk density...
Effect of Moisture and Bulk Density Sampling on Neutron Moisture Gauge Calibration
Three moisture and bulk density sampling methods were evaluated for use in neutron gauge calibration. Each of the methods was comprised of a single core or portions of a core taken during...
London Linkage
Although it measures just 1.8 km, the Limehouse Link tunnel in London is both a complex engineering project and a gateway to urban renewal. The link is a $350 million highway tunnel connecting...
Optimization Modeling for Sedimentation in Alluvial Rivers Considering Uncertainties
A nonlinear optimization model is formulated for determining optimal reservoir releases to minimize channel bed aggradation and degradation in downstream rivers. The model is based upon...
Return to search