Study of Three Dimensional Crack Tip Location of Mortar by Acoustic Emission
Plain mortar specimens were tested under three-point bending. Experimental variables include the width of the specimen and the notch-to-depth ratio. The experimental results of 12 specimens...
Concrete Beam Testing with Optical Fiber Sensors
The use of an embedded multimode optical fiber to monitor curing and load-to-failure testing of a reinforced concrete beam has been investigated. The embedding process used to network...
Condition Monitoring of Structures Using Transient Response
Condition monitoring of structures by measuring transient response and tracking the derived modal parameters has been applied with success in three laboratory studies. Where modal parameters...
Nondestructive and Destructive Testing of a Three Span Skewed R. C. Slab Bridge
A three span, skewed, reinforced concrete slab bridge was field tested to destruction by the authors. Before the actual destructive test, nondestructive tests were performed to determine...
On the Influence of Seismically Induced Residual Forces on Bridge Abutment Design
The seismic design of bridge abutments depend on the anticipated movement of the abutment during the design earthquake. For seat-type abutments in which the backfill resistance can be...
Damage Dependent Micromechanics in Metal Matrix Composites
A computational approach is used herein to model the effects of processing induced thermal residual stresses on radial, hoop, and shear stresses at the fiber/matrix interface in a continuous...
Constitutive Modeling and Simulation of Energy Absorbing Polyurethane Foam Under Impact Loading
The compressive-stress strain response of polyurethane foam under uniaxial compressive impact loading has been studied. The development of a uniaxial constitutive model from strain rate...
On the Diffusional Stress Transmission
A probabilistic diffusional mechanism for the propagation of intergranular forces has been formulated as a set of three mathematical assumptions. The equilibrium equations are complemented...
Wavelet Transform Analysis of Several Transient or Nonstationary Phenomena in Engineering Mechanics
Several examples of the use of a wavelet transform in the analysis of transient events in mechanical systems are provided. The transform has the advantage over other transient analysis...
Comparative Evaluation of Plasticity Theories Against Tension-Torsion Test at Finite Strain
This paper investigates and evaluates three hardening theories against a variety of nonproportional loading experiments on tubes made of annealed copper. It was concluded that the isotropic...
Refined Analysis of Load Distribution Factors for Bridges
This paper presents a new approach for calculating the distribution factors for slab-on-girder bridges. This method considers the coupling of longitudinal and transverse effects. The governing...
Size, Temperature and Rate Effects on the Fracture Toughness of Saline Ice
This paper presents the results of an extensive experimental study performed with the aim of investigating the effects of temperature, size and loading rate on the fracture toughness of...
Soil Behavior from Unconventional Loading Conditions
Random and sinusoidal loading conditions were used in this study to determine the soil moduli and the damping ratios of cohesive soil samples. Test results showed some differences between...
Dynamic Analysis of Sliding Seismic Isolators
The friction pendulum system (FPS) sliding seismic isolators are being used for the seismic isolation rehabilitation of the U.S. Court of Appeals Building, San Fransisco. This paper will...
Dynamic Response of an Infinite Beam Supported by a Fluid
The objective of this study is to investigate the dynamic response of an infinite beam supported by a fluid on one side, and subjected to dynamic loading on the other side. The fluid underneath...
Determination of In-Situ Stresses From Acoustic Emissions
Acoustic emissions (AE) are microseismic activities that are generated in concrete by cracking and damage. The rate of Acoustic Emissions, called the 'Event Rate', can provide indication...
Evaluating Polymer Concrete Bridge Expansion Joints Using Acoustic Emission
This study is to simulate the acoustic emission (A/E) of polymer concrete bridge expansion joints subjected to controlled representative loads by a rotating test apparatus on a circular...
Detection of Cracks in Reinforced Concrete Cans
The Acoustic Emission Technique (AET) is known as a good possibility for non destructive detection of cracks in metal down to very small dimensions. To use AET for concrete, an efficient...
Numerical Integration of Transient Creep Constitutive Equations for Polycrystalline Ice
A numerical time integration algorithm is developed to solved the system of coupled, first-order differential equations characterizing the physically-based constitutive model of Shyam...
Modal Coupling Effect of Non-Classically Damping
The equations of motion of a structure in undamped modal coordinates may have non-zero off-diagonal terms in the damping matrix. Although these terms are commonly neglected, studies have...
Return to search