Strength Design for Reinforced-Concrete Hydraulic Structures
21st Century Timber Engineering
Timber engineering is moving into the 21st Century faced with challenges in technology, governmental mandates and environmental concerns. Engineers are continuously being challenged in...
Engineering Sustainable Development
Despite some isolated environmental victories in the past few decades, on a system-wide level the problems�from acid rain to destruction of the rain forest�are getting worse. Can humanity...
Finite Element Analysis of Reinforced Concrete Structures II
This proceedings,
Dynamic Response and Progressive Failure of Special Structures
This proceedings,
Managing Work
Managers often ask engineers to do more work without providing more resources to support the requests. In response, engineers typically counter that they need more resources (time, money,...
Design and Proposed Construction Techniques for Pangue Dam
The paper describes the site conditions, design and proposed construction methods for the 115 m high Pangue Dam, Chile's first RCC dam. Trial mix design work and test embankments...
Thermal Analysis for RCC?A Practical Approach
Roller compacted concrete (RCC) structures, by nature of the construction method, tend to be monolithic structures or structures with minimal contraction jointing. Recurring questions...
Tomorrow's Schools
While what's wrong with education looms as a national concern, many communities are doing something positive about it. They're constructing new schools designed...
Designing Reinforced Rock
The reinforced rock arch design method has been used to stabilize coal mine excavations for 40 years, but so far has been applied to only a few tunnels. The use of rock reinforcement develops...
Naval Pier Foundation Design and Construction, Pearl Harbor, Hawaii
The paper presents a case study of foundation design and construction for a pier in Pearl Harbor. The study covers a review of site investigations, laboratory testing, pile selection and...
Study of Three Dimensional Crack Tip Location of Mortar by Acoustic Emission
Plain mortar specimens were tested under three-point bending. Experimental variables include the width of the specimen and the notch-to-depth ratio. The experimental results of 12 specimens...
Concrete Beam Testing with Optical Fiber Sensors
The use of an embedded multimode optical fiber to monitor curing and load-to-failure testing of a reinforced concrete beam has been investigated. The embedding process used to network...
Nondestructive and Destructive Testing of a Three Span Skewed R. C. Slab Bridge
A three span, skewed, reinforced concrete slab bridge was field tested to destruction by the authors. Before the actual destructive test, nondestructive tests were performed to determine...
On the Influence of Seismically Induced Residual Forces on Bridge Abutment Design
The seismic design of bridge abutments depend on the anticipated movement of the abutment during the design earthquake. For seat-type abutments in which the backfill resistance can be...
Damage Dependent Micromechanics in Metal Matrix Composites
A computational approach is used herein to model the effects of processing induced thermal residual stresses on radial, hoop, and shear stresses at the fiber/matrix interface in a continuous...
Constitutive Modeling and Simulation of Energy Absorbing Polyurethane Foam Under Impact Loading
The compressive-stress strain response of polyurethane foam under uniaxial compressive impact loading has been studied. The development of a uniaxial constitutive model from strain rate...
On the Diffusional Stress Transmission
A probabilistic diffusional mechanism for the propagation of intergranular forces has been formulated as a set of three mathematical assumptions. The equilibrium equations are complemented...
Comparative Evaluation of Plasticity Theories Against Tension-Torsion Test at Finite Strain
This paper investigates and evaluates three hardening theories against a variety of nonproportional loading experiments on tubes made of annealed copper. It was concluded that the isotropic...
Refined Analysis of Load Distribution Factors for Bridges
This paper presents a new approach for calculating the distribution factors for slab-on-girder bridges. This method considers the coupling of longitudinal and transverse effects. The governing...
Return to search