Perimeter Load Transfer in Drilled Shafts in the Eagle Ford Formation
Results of six full-scale compression loading tests at four sites in the Dallas area are considered. Compressive strengths (qc) of the rock varied...
Side Resistance of Drilled Shafts in the Denver and Pierre Formations
Results of load tests on drilled shaft foundations in Upper Cretaceous shales are described and evaluated. Three load tests were conducted on shafts in the Denver Formation, in Denver,...
Behavior of Instrumented Model Piers in Manufactured Rock with a Soft Layer
A laboratory test apparatus has been used to study the side resistance of piers socketed into manufactured soft-rock masses. The results of four tests are reported, three of which included...
A Laboratory Procedure for Partial-Wetting Collapse Determination
Partial wetting results in partial collapse, which is linked to the reduction in soil suction caused by wetting. The laboratory procedure presented in this paper represents a modification...
Strength Design for Reinforced-Concrete Hydraulic Structures
21st Century Timber Engineering
Timber engineering is moving into the 21st Century faced with challenges in technology, governmental mandates and environmental concerns. Engineers are continuously being challenged in...
Finite Element Analysis of Reinforced Concrete Structures II
This proceedings,
Dynamic Response and Progressive Failure of Special Structures
This proceedings,
Managing Work
Managers often ask engineers to do more work without providing more resources to support the requests. In response, engineers typically counter that they need more resources (time, money,...
Design and Proposed Construction Techniques for Pangue Dam
The paper describes the site conditions, design and proposed construction methods for the 115 m high Pangue Dam, Chile's first RCC dam. Trial mix design work and test embankments...
Thermal Analysis for RCC?A Practical Approach
Roller compacted concrete (RCC) structures, by nature of the construction method, tend to be monolithic structures or structures with minimal contraction jointing. Recurring questions...
Tomorrow's Schools
While what's wrong with education looms as a national concern, many communities are doing something positive about it. They're constructing new schools designed...
Designing Reinforced Rock
The reinforced rock arch design method has been used to stabilize coal mine excavations for 40 years, but so far has been applied to only a few tunnels. The use of rock reinforcement develops...
Naval Pier Foundation Design and Construction, Pearl Harbor, Hawaii
The paper presents a case study of foundation design and construction for a pier in Pearl Harbor. The study covers a review of site investigations, laboratory testing, pile selection and...
Study of Three Dimensional Crack Tip Location of Mortar by Acoustic Emission
Plain mortar specimens were tested under three-point bending. Experimental variables include the width of the specimen and the notch-to-depth ratio. The experimental results of 12 specimens...
Concrete Beam Testing with Optical Fiber Sensors
The use of an embedded multimode optical fiber to monitor curing and load-to-failure testing of a reinforced concrete beam has been investigated. The embedding process used to network...
Nondestructive and Destructive Testing of a Three Span Skewed R. C. Slab Bridge
A three span, skewed, reinforced concrete slab bridge was field tested to destruction by the authors. Before the actual destructive test, nondestructive tests were performed to determine...
On the Influence of Seismically Induced Residual Forces on Bridge Abutment Design
The seismic design of bridge abutments depend on the anticipated movement of the abutment during the design earthquake. For seat-type abutments in which the backfill resistance can be...
Damage Dependent Micromechanics in Metal Matrix Composites
A computational approach is used herein to model the effects of processing induced thermal residual stresses on radial, hoop, and shear stresses at the fiber/matrix interface in a continuous...
Constitutive Modeling and Simulation of Energy Absorbing Polyurethane Foam Under Impact Loading
The compressive-stress strain response of polyurethane foam under uniaxial compressive impact loading has been studied. The development of a uniaxial constitutive model from strain rate...
Return to search