Correlation of Soil Parameters From In Situ and Laboratory Tests for Building 333
Pressuremeter, plate bearing and cone penetration tests were performed on the prepared foundation soil for Building 333 located in the Red River Army Depot near Texarkana, TX. The results...
Strength of Fine-Grained Soils Using the Piezocone
Evaluation has been made of several theories and methods for deducing the undrained and effective stress strength of saturated fine-grained soil from piezocone test results. Bearing capacity...
Dilatometer Tests in Sand
The paper presents two applications of the dilatometer test in sands: control of compaction and determination of constrained modulus. Twelve dilatometer tests were carried out before and...
Pore Pressure Effects in Borehole Shear Testing
The effects of excess pore pressures on shear strength results obtained using the Borehole Shear Test (BST) were investigated. Pore pressures were measured during the consolidation, shear,...
Determining Sand Strength by Cone Penetrometer
Evaluation has been made of several theories and methods for deducing sand strength from cone resistance. Bearing capacity theories, cavity expansion theory, and empirical methods have...
The Mudslide Profile Method to Measure the Undrained Shear Strength of Muds
Mudslides have been reported to have a very distinctive profile. Using this distinctive profile, a method is presented to analyze the stability of the mudslide at limit equilibrium conditions....
Vane Shear Testing for Staged Construction
Staged construction was used for the earthfill embankment of Birch Dam in order to compensate for low strength clays in the foundation. Sampling and testing of foundation soils verified...
Interpretation of CPT Data for Design of Earth Dams Near Tehachapi, California
The Static Cone Penetration Test (CPT) was used to obtain needed geotechnical information for design and construction of two small earth dams near Tehachapi, California. The basic CPT...
Fast, Economical, Cone Testing of River Sediments
The objective of the study reported was to obtain quantitative geotechnical information over many square miles of Hudson River bottom. A hand held cone penetrometer was selected for use....
Dilatometer to Compute Foundation Settlement
Sixteen examples demonstrate how the S. Marchetti dilatometer test (DMT) provides soil compressibility data for the rapid calculation of foundation settlements with an average ratio of...
Relative Landslide Susceptibility in Davis County, Utah?A Multivariate Approach
The complex distribution of soil properties makes prediction of slope stability extremely difficult in these mountain watersheds. The need to assess these watersheds for their susceptibility...
Erosion and Sedimentation Processes in Irrigation
Soil erosion occurs when fluid in motion detaches and transports soil particles. Sedimentation occurs when the fluid transport capacity decreases. Both the hydraulic forces of moving water...
Available Compaction Equipment
When discussing available compaction equipment we must keep in mind the purpose of compaction. Compaction is the art of artificially increasing the density or increasing the unit weight...
Structural Applications of SIFCON
SIFCON (Slurry Infiltrated Fiber CONcrete) is a relatively new composite material utilizing steel fibers in a cement-based matrix. It differs from conventional steel-fiber-reinforced concrete...
Effects of High Pressure and Temperature on HCP
A modification of fabrication techniques for cement paste can significantly affect its properties. Specifically, the static compressive strength can be increased over that of specimens...
The Assessment of Freeze-Thaw Damage in Cement Stabilised Soils
Whilst the ASTM Freeze-thaw test was not originally conceived as a means for classifying the frost resistance of cement stabilised soils it has become accepted for this purpose, with the...
The Concrete Diagonal
Onterie Center in Chicago, Fazlur Kahn's last major structural design, is a companion in concrete to the diagonally braced steel John Hancock Center. It is a mixed-use building...
Geotechnical Features of Fur Seal Island Design
In summer 1983, Texaco made plans to construct an artificial island in Harrison Bay of the Beaufort Sea to serve as a platform for exploratory drilling. Fur Seal Island is to be located...
Soil Cement Shore Protection in Arctic Environment
Suitability of compacted and plastic soil cement prepared with sea water, for shore protection of islands in Arctic marine environment, is investigated. The laboratory test results indicate...
Soil Strength Determinations from the Cone Penetrometer Test
Geotechnical exploration in offshore Arctic regions often relies upon the electric Cone Penetrometer Test (CPT) because of its speed, economy, data continuity, and general reliability....
Return to search