Seismic Resistant Low-Cost Masonry Buildings in Peru
Future housing in developing countries will be provided mainly in medium rise, four to six stories, bearing wall masonry buildings. This paper reports on the rationality behind this political...
Flexural and Shear Moduli of FRP Beams
The analysis and design of structures of pultruded fiber reinforced plastic (FRP), constant cross-section, commercially produced, beams is discussed in the context of a shear deformation...
Ultimate Strength and Deformation of RC Panels
In this study, twenty reinforced concrete panels have been tested under pure shear. Test results showed that the compressive strength of concrete strut was strongly affected by bond characteristics...
Analytical Model for RC Panels Under Cyclic Load
There are several existing constitutive laws for cracked concrete and steel in RC developed in Okamura laboratory. These models have been developed and verified through reversed uniaxial...
Lateral Force Distribution in Manufactured Housing from Full-Scale Testing
The research focused on the behavior of two manufactured 14 ? 66 ft houses under simulated wind loads. Extensive instrumentation was employed to insure the collection of data that would...
Panel-Sheathed Shear Walls ? Past and Future
In order for a building to resist the lateral forces caused by wind or earthquake, it is necessary that the building include a lateral force resisting system. When the walls are designed...
Lessons Learned from Dynamic Tests of Shear Panels
Thirteen 8-ft by 8-ft shear panels and fifteen 16-in by 18-in shear panels were tested dynamically at the Structural Testing Laboratory, Richmond Field Station, University of California,...
A Structural Analysis Model for Timber Shear Walls
A numerical modelling procedure for the non-linear analysis of timber shear walls is presented. The model includes the non-linear behavior of the connectors between the sheathing and framing,...
Shear Strength of P.P.C. Beams
50 beams of partially prestressed concrete were tested and 82 data of the ultimate shear-strength were obtained. Based on these results, this paper studies the effects of the degree of...
Macroscopic Models for R/C Shear Walls
In this paper, the discussion is mainly focused on four macroscopic models, recently proposed by Japanese researchers, for predicting ultimate strength of reinforced concrete (R/C) shear...
Verification of Macroscopic Models for R/C Walls
Macroscopic models utilized in a plastic analysis for predicting the ultimate strength of reinforced concrete members have been developed in Japan as well as in Europe. In the JCI committee,...
Verification of Macroscopic Models or RC Walls by FEM
Several macroscopic models based on the limit analysis have been proposed for obtaining the ultimate strength of reinforced concrete shear walls in Japan. When using these models, it is...
Parametric Analyses of RC Shear Walls by FEM
In this paper, nonlinear behavior of reinforced concrete shear walls is studied by using the finite element analysis. We applied numerical analyses to a wide range of parameters, such...
LRFD for U. S. Bridge Design ? Validation Issues
During the 1987 meeting of the AASHTO Subcommittee on Bridges and Structures, recommendations from the National Cooperative Highway Research Program (NCHRP), Project 20-7/31, regarding...
Energy Approach of Earthquake-Structural Design Analysis
A new procedure developed from the earthquake energy concepts is presented in this paper. A short-squat building and a long-slender building are analyzed using the presented procedure....
Wind Performance of Asphalt Roofing Shingles
Pre-seal and post-seal wind resistance of asphalt roofing shingles is discussed. A test method for evaluating pre-seal wind damage is described. Wind tunnel testing results are presented...
Seismic Response of Multistory Building Structures With Flexible Floor Diaphragms
An efficient model for three-dimensional analysis of multistory structures with flexible floor diaphragms is proposed in this paper. Three-dimensional analysis of a building structure...
Toward an LRFD-Based AASHTO Bridge Specification
During the 1987 AASHTO Bridge Committee Meeting, recommendations from NCHRP Project 20-7/31 regarding the development of a probability-based LRFD bridge specification were accepted. NCHRP...
Evaluation of Bridge Safety and Remaining Life
In developed countries, the emphasis on the infrastructure is changing from new construction to the safe maintenance of existing structures. Highway bridges represent an excellent example...
Load and Resistance Factor Design for Engineered Wood Construction
The wood industry has provided sponsorship for the development of a reliability-based, load and resistance factor design specification for engineered wood structures. This user-tested,...
Return to search