Regional Beach Sand Volumes of the Pacific Northwest, USA
Eight small littoral cells ranging from 5-60 km in length have been surveyed by beach profiling and seismic refraction to establish active beach sand volumes in the Pacific Northwest region....
Integrated Photogrammetric and Geophysical Monitoring of Shoreline Instability in Littoral Cells in the Pacific Northwest, USA
Several factors have recently focused on the attention of government agencies, academic researchers, and the general public on coastal erosion and beach resource management in the Pacific...
Effects of Temperature and Mean Cell Residence Time on Enhanced Biological Phosphorus Removal
The effects of temperature and mean cell residence time (MCRT) on biological phosphorus and nitrogen removal were investigated by operating pilot-scale continuous-flow activated sludge...
Magnetic Fluid Conditioning
Industry is now turning to develop magnetic water treatment in an effort to discontinue the use of chemicals. Magnetic water treatment takes a different approach to solving the same problem...
The Great Canadian Bridge Slide
An aging multispan swing bridge had to be replaced in Trenton, Ont., with minimal interference to both river and road traffic, and without changing its alignment. The solution was to build...
CADD for Export
By using sophisticated structural design software and high-speed PCs, engineers in Pittsburgh overcame myriad problems when designing a highrise industrial tower in India. First, they...
Dam Safety Hydrologic and Seismic Evaluation of TVA'S Beech Dam
Beech Dam is part of the Beech River watershed resource development located in Decatur and Henderson counties in west Tennessee. The development consists of eight dams and approximately...
Geotechnical Aspects of the Underground Excavations at the Kemano Completion Project
The Kemano Completion Project is the addition of four generators of 540 MW installed capacity to an existing eight-unit underground hydroelectric generating station owned and operated...
The Stabilization of Minidoka Powerplant and Dam
The rehabilitation of structures can pose numerous challenges to the engineer. The structure historical preservation, the benefit cost ratio of the rehabilitation, and the stability of...
Seismic Analysis of the Bonneville 1st Powerhouse
The Bonneville 1st powerhouse monoliths were constructed during the period of 1938 to 1942 and were designed against seismic loads using the old lateral coefficient method. The Corps of...
Concrete Gravity Dam Cracking Analysis Methodology
This paper describes a methodology for the prediction and evaluation of cracking behavior in concrete gravity dam's for use in periodic safety investigations as outlined in...
Composite Materials Show Promise for Clean Kaplan Runners
In order to prevent any possibility of oil leakage into river water, LMZ manufactured Kaplan runners containing oil in the blade servomotor only, while the blade operating mechanism operates...
Hydro Plant Modernization and Uprating
The paper suggests that the method to achieve desirable hydropower benefits at costs lower than for new thermal projects, is through systematic modernization and upgrading of older hydro...
Thermal Regimes at Tailwaters of Hydroelectric Dam
Continuous temperature data were collected in the field for periods of approximately two weeks in Center Hill Tailwater. These data were analyzed to determine the warming rates and travel...
Effect of Nile River Flow on Performance of Shoubrah Power Plant Cooling System
Shoubrah El-Khimah Power Plant was built in 1982. Its peak capacity is 1200 MW, generated by four units, three of them having one cooling water intake. The cooling water pumps suffer from...
Environmental and Hydraulic Considerations in the Design of a Circulating Water Cooling System
Environmental considerations play an important part in the design of a condenser cooling system. A once-through system may require assessment of a combination of events to determine the...
Design of a Stratified Cooling Channel
Cooling ponds are used for managing waste heat discharges. Cooling ponds are, however, expensive to construct and operate. A cooling channel is studied as an alternative means of managing...
Comparison of a Vibrational Gage and a Plummet for Continuously Measuring Fluvial-Sediment Concentrations
Obtaining sediment records for small, remote streams is difficult not only because of the logistical problems, but also because of the rapid changes in concentration that accompany the...
Seismic Design Issues for Immersed Tube Tunnels
This paper provides an overview of the issues and the state of the art techniques in the seismic design of immersed tube tunnels (ITT). Particular focus is given to the ITT presently planned...
Ductile Frames Are Tough for Earthquakes
Implications of a new structural system in wharf design go far beyond San Francisco Bay, where two such wharves remained intact after the 1989 Loma Prieta quake. The design, introduced...
Return to search