Analysis of Cabinet Gorge Dam
After a 1987 inspection of the Cabinet Gorge Dam, Part 12 consultants contracted by Washington Water Power (a private utility based in Spokane, Washington) made several recommendations...
Dam Safety Modifications for Clear Creek Dam Manuscript for ASCE Hydraulics Division 1993 National Conference on Hydraulic Engineering
Clear Creek Dam, an unsafe thin arch dam, was stabilized by constructing a concrete gravity buttress on the downstream face. During the Bureau of Reclamation's (Reclamation) Safety Evaluation...
Protecting the Boca Raton Outfall Before and After Hurricane Andrew
A critical factor for the success of an ocean outfall is its ability to remain intact and functional for many decades of service, despite extreme episodes of wave attack and beach erosion....
Case Studies of Bridge Scour in Western New York
As part of the New York State Thruway Authority's bridge hydrologic/hydraulic evaluation program, 63 structures over 42 stream crossings in western New York were assessed for scour potential...
Design and Performance of Emergency Spillway Channel Erosion Protection?Grenada Lake Dam, Grenada, Mississippi
Grenada Lake Dam located on the Yalobusha River in northeast Mississippi is part of the Mississippi River and Tributaries comprehensive plan for flood control. The 13,000-ft-long earthfill-type...
Scour Development at Isolated River-Bed Obstacles
Development of local scour was investigated for isolated obstacles on movable beds subject to clear-water scour. The resulting maximum scour depths, scour volumes, and obstacle displacements...
Numerical Solution of Transient Closed-Conduit Flow Equations by the Method of Lines Along Characteristics
The method of characteristics has long been considered as a natural technique for solving transient closed-conduit problems. In this paper, by using the concept of the method of lines,...
Laplace Valve Stroking to Control Water Hammer
The method of Laplace valve stroking to control water hammer is presented. Attention is directed to the most frequently encountered of the simple systems: a single pipe originating at...
Shape Effect on Bed-Load Transport in Pipes
The nature of part-full flows in pipe sewers produces different channel shapes resulting in non-uniform shear stress distribution on the wetted perimeter. New experimental data were utilized...
Regulation of Flow Downstream of Weirs
Reregulation weirs are one means adopted by the Tennessee Valley Authority (TVA) to provide continuous improved minimum flow and wetted area for aquatic life downstream if hydroprojects...
Storm Drainage Channel Rehabilitation
30 km (19 miles) of existing concrete lines storm drainage channels were studied due to repeated failures. Alternate failures causes were hypothesized and evaluated. Physical testing was...
Determination of Hydraulic Roughness for Concrete-Lined, Supercritical Channels
A channel verification program has been initiated by the US Army Engineer District, Los Angeles to determine the hydraulic roughness of flow in a concrete channel. Specifically, this study...
Cable-tied Concrete Block Erosion Protection
An articulated concrete erosion protection system is investigated as a possible revetment for bridge piers to be used in place of the traditional rip-rap revetment. The system consists...
Friction Loss Equations for Hydropower Facilities
Many water suppliers are pursuing economic benefits from water supply and distribution systems through development of hydropower facilities on pipelines. Excessive pressure head that used...
Debris Flow Initiation and Termination in a Gully
A comprehensive simulation model predicting the debris-flow discharge hydrograph, solids concentration in it and the process of variation of the channel due to vertical as well as lateral...
Methods for Prediction of Maximum Scour at Coastal Structures
The most common coast scour-related problems are toe scour at rubble mound structures and vertical seawalls, and scour at the base of piles and horizontal pipelines. Existing scour prediction...
A New Type of Concrete Trapezoid Dam
A new type of 128.0 m height concrete trapezoid dam (t-d) has been built for the Wunana Town Hydroelectric Power Station (WTHPS). The paper presents its optimum section design, several...
New Developments in Eurocode 4
The European Community has initiated the preparation of a set of harmonized structural codes. Eurocode 4 is the code for the design of composite steel and concrete structures. The first...
Composite Beams: Redistribution, Reliability, and Lateral Buckling
Research relevant to three aspects of the design of composite beams for ultimate limit states is summarized. These are: the redistribution in continuous beams and in framed structures...
Chinese Standard for Concrete-Filled Tube Columns
In this paper an outline is given of the background, the design approach and some principal features of the Chinese Specification for the Design and Construction of Concrete-filled Steel...
Return to search