An Application of Probability to Rock Slope Design
This paper describes the use of probability and statistics in the slope design process. An example is presented of a high rock slope in an open pit mine. This slope is a major concern...
A Combined Limit Equilibrium and Statistical Analysis of Wedges for Design of High Rock Slopes
This paper describes a unique technique developed for the statistical analysis of wedge failures which control the design of high slopes in relatively hard jointed rock masses. Using this...
Probability Applied to Slope Design?Case Histories
A major problem encountered with the choice of an appropriate value for the design probability. Initial experience, obtained during open-pit investigation, suggested that slope geometry...
Fracture Mechanics Analysis of Massive Hydraulic Fracturing Containment
The hydraulic fracturing containment problem is the subject of the present investigation. Unlike previous studies, the interface crack geometry with the correct crack tip singularity was...
Prediction of Highway Construction Noise Levels
A model for the prediction of noise levels from highway construction operations has been developed under sponsorship of the Federal Highway Administration (FHWA). Noise sources are geometrically...
On the Design of Continuous Composite Beams
Methods of analysis and design of continuous composite beams are presented. Numerical analysis is used to determine the effective width of the slabs to be used in design. The influence...
Proposed Design Criteria for Composite Steel Deck Slabs
Composite steel deck slabs have continued to gain popularity; today they are one of the predominant means of floor slab construction in most typical buildings. The term 'composite...
Strength of Biaxially Loaded SRC Columns
The paper presents the results of an experimental study on the elasto-plastic behavior of 'Steel reinforced concrete (SRC)' columns subjected to biaxially eccentric...
Composite and Mixed Construction in Czechoslovakia
Various composite and mixed systems have been used in Czechoslovakia. Special attention is focused on design methods, effective construction, and material savings. Current developments...
Checking Off CADD Priorities
Diving head on into new computer aided design and drafting (CADD) hardware and software without considering their effects on firm or university's operation is as bad as ignoring...
Critical Load Program
The elastic critical load of a structural frame is a fundamental parameter in assessing its stability. It is an upper bound to the failure load of the frame, in the same way that the Euler...
Computer Impacts on Water Resources Engineering
Computation capability has increased by a factor of one million over the past 30 years and has contributed greatly toward data management and the application of available technology to...
Computers in a Planning Context: Another Reality
Over the past twenty years water resources planning has seen a great increase in the development of computer methods of analysis. This has transformed the way the hydrology, hydraulics,...
Maximum Water Source Utilization Using Lotus 1-2-3
This paper discusses the use of microcomputers to determine the optimum mix of sources for the Fargo-Moorhead area's water supply network. The area's major water...
Personal Computers and Stormwater Management Programs
Urban flooding and drainage problems are the result of complex interactions between natural and man-made systems. Comprehensive analysis of the hydrologic characteristics of these problems...
Micro Use in Water Management in the Brazos Basin
The Brazos River Authority, an agency of the State of Texas created to conserve and develop the surface waters of the 42,000 square mile (110,000 km) Brazos River Basin, is in the midst...
Use of Spreadsheets in Stormwater Modeling
The use of microcomputers is becoming more and more prevalent in both large and small design offices as their first cost continues to decrease, as their capabilities continue to increase,...
A Micro-Computer GIS for Water Resources Planning
Recent developments in micro-computers have enabled water resources engineers to utilize advanced computer methods and interactive color graphics for the analysis and planning of water...
Water Resources Applications of OCAP--Ohio's CNRIS
The Ohio Capability Analysis Program (OCAP) is a computer-based natural resources information system (CNRIS) operated since 1973 by the Ohio Department of Natural Resources. The three...
Storage Projection for Reservoir Systems
Two methods are studied for determining the probability distribution of future levels of storage in a reservoir system: transient analysis and Gould's probability matrix method....
Return to search