In Situ Tests Aid Design of a Cylinder Pile Wall
In situ testing was used to verify geotechnical design parameters and modify construction for a 22 million dollar slope stabilization project near a major highway interchange. The project...
Correlation of Soil Parameters From In Situ and Laboratory Tests for Building 333
Pressuremeter, plate bearing and cone penetration tests were performed on the prepared foundation soil for Building 333 located in the Red River Army Depot near Texarkana, TX. The results...
Pore Pressure Effects in Borehole Shear Testing
The effects of excess pore pressures on shear strength results obtained using the Borehole Shear Test (BST) were investigated. Pore pressures were measured during the consolidation, shear,...
The Mudslide Profile Method to Measure the Undrained Shear Strength of Muds
Mudslides have been reported to have a very distinctive profile. Using this distinctive profile, a method is presented to analyze the stability of the mudslide at limit equilibrium conditions....
Vane Shear Testing for Staged Construction
Staged construction was used for the earthfill embankment of Birch Dam in order to compensate for low strength clays in the foundation. Sampling and testing of foundation soils verified...
Seepage Studies Using Tracers and the Self Potential Test
Mill Creek Dam, a homogeneous silt structure resting on a conglomerate foundation, has experienced severe 'seepage since its construction in 1941. In 1981, a concrete cutoff...
Analysis of Liquefaction Potential by Insitu Testing
This paper describes the results of insitu testing performed to assess the liquefaction potential of a sand formation at a site for a proposed large industrial facility in East Central...
Effctive Stress Interpretation of In-situ Tests
Significant differences in terms of load-settlement curves obtained from Plate Load Tests (PLT) and q//c profiles obtained from Static Cone Penetration Tests (SCPT) at two sites with different...
Fast, Economical, Cone Testing of River Sediments
The objective of the study reported was to obtain quantitative geotechnical information over many square miles of Hudson River bottom. A hand held cone penetrometer was selected for use....
In Situ P and S Wave Velocity Measurement
A review of the in situ techniques to measure P and S wave velocities by seismic wave propagation is presented. A relatively new technique, the suspension PS logging method, is described...
In-Place Permeability Measurement of Slurry Trench Cutoff Walls
A suggested procedure for the in-place measurement of slurry trench cutoff wall permeability is presented. The H. Bouwer and Rice method, employing a single observation well and variable-head...
In Situ Tests for Foundation Vibrations
There are several well established methods of determining shear modulus in situ and these are summarized in this paper. New techniques are being developed for in situ determination of...
In Situ Tests on a Florida Peat
A geotechnical exploration program at a site predominated by surface peats has been performed. The study encompasses the performance of in situ field tests and laboratory soil tests. Field...
Effect of Particle Size on Sludge Dewaterability
Using a modified Buchner funnel apparatus to measure specific resistance and a sequential centrifugation/filtration procedure to fractionate a sludge, it was possible to more precisely...
Coastal Protection Guidelines, Orange County, GA
As a result of coastal storms in the past several years the County of Orange (California) incurred large and unanticipated costs in providing emergency protection for private shorefront...
Effect of the Fluid Velocity on the Biofilm Development
In order to get basic information concerning the application of a biological treatment to the ammonia nitrogen removal from drinking water, we considered the relation between the biofilm...
Physical Habitat Simulation and the Moveable Bed
One objective of an instream flow analysis is to quantify a flow that will maintain the existing channel and/or flush fine material from the bed. Five empirical approaches to determine...
Alterations to Old Wood Building
In order to accommodate a new use, a request was made to remove bearing walls supporting the roof of a 42 year-old building and substitute timber posts. The existing nine-foot ceiling...
A Study of Exterior Facades?Problems and Solutions
The quality of the exterior facades of a building is important to maintaining aesthetic image, protecting the interior environment from infiltration of heat, cold, moisture, wind, and...
The Basics of Water-Resistant Brick Walls
Water-resistant masonry walls of burned clay or shale brick are the result of a conscious effort to produce them, by everyone involved in their creation. Furthermore, owner maintenance...
Return to search