Dam Safety Emergency Action Plans?A TVA-State Responsibility
The Federal Guidelines for Dam Safety requires each dam owner to prepare and maintain emergency action plans (EAP) for each of structure. These plans are necessary (1) to identify problems...
Milltown Powerhouse Rehabilitation
The Milltown Powerhouse and dam are over 80 years old. The powerhouse and other structures were built in 1906 and are owned by the Montana Power Company. The plant is located on the Clark...
Major Hydraulic Turbine Operation and Maintenance Problems Experienced by the Corps of Engineers
The U. S. Army Corps of Engineers is the largest owner/operator of hydroelectric power generating facilities in the United States with 344 generating units, having an installed capacity...
Synopsis of Harry S. Truman Turbine Repair
The Harry S. Truman Powerplant was designed and constructed under the supervision of the U. S. Army Corps of Engineers and is located on the Osage River near Warsaw, Missouri. During 1981...
Influence of Surface Finish on Thrust Bearing Life
The original pivoted pad thrust bearing installed and fitted at the Holtwood Power Station in 1912 by A. Kingsbury has been operating continuously since that time without any difficulty....
Accelerated Life Testing of Generator Coils
This paper presents a step-by-step procedure for doing a 400 hour, 60 Hz, 90 degree C accelerated life test on generator coils. Test procedure is as follows: 1. Initial coil examination...
Fretting Corrosion on Large Split Thrust Bearing Runners
In the early fifties interfacial slip was measured on laboratory models. Design improvements, resulting from these tests, were incorporated into later machines. These improvements appreciably...
Upriver Dam Hydroelectric Project Rehabilitation After Failure, Part A: Failure Investigation and Lessons to be Learned
A lightning strike caused electrical failure at Spokane's two Upriver power plants, resulting in the river overtopping Project embankments, and causing nearly 11. 5 million...
Upriver Dam Hydroelectric Project Rehabilitation After Failure, Part B: Rehabilitation and Enhancement of Project Civil and Mechanical Facilities
A feasibility investigation of rehabilitation alternatives was conducted which identified several alternatives for repairing the damage and placing both powerhouses back on-line. These...
Treatment of Karst Along Tennessee Highways
The construction and maintenance of highways in karst areas of East Tennessee has resulted in the occurrence and treatment of induced sinkholes along the ditchlines of numerous highways....
Finite Element Analyses of the St. Alban Test Embankments
Finite element analyses were performed of three embankments on sensitive clay that were constructed to failure at St. Alban, Quebec. One of the embankments was reinforced with flat-lying...
Laboratory Study of Geogrid Reinforced Soil Walls
The paper describes the construction and testing of three (3) large-scale geogrid reinforced soil retaining wall models. The models were 3 m high and were built in the RMC Retaining Wall...
Probabilistic Prediction of Pile Group Capacity
A reliability analysis of a group of free standing piles in clay is carried out using Monte Carlo simulation. The pile material strength, soil capacity, and the load on the pile group...
Fracture Control for Arctic Vessels and Structures
Materials used for construction of Arctic structures and vessels are exposed to low ambient temperatures, high local ice loads and intermediate to high loading rates. All these factors...
Methods to Estimate Parametric Sensitivity in Structural Reliability Analysis
Many different approaches are used in structural system reliability to estimate the probability of failure. In this paper, methods to obtain the sensitivity to the distribution parameters...
On the Evaluation of System Reliability Through Automatic Generation of Failure Modes
This paper proposes a method for the evaluation of structural failure probability taking into account all the potential failure modes. At first, the failure paths to produce failure modes...
Reliability Based Analysis of Contact Problems
The S.B. Batdorf model is modified to include the reduction in shear due to the effect of compressive stresses on the crack face. This new formulation was used to obtain the probability...
Reliability of Geotechnical Systems Considering Geological Anomaly
Anomaly statistics at a given site are first assessed through Bayesian methodology on the basis of site exploration data. Several methods may be then used to incorporate the anomaly uncertainties...
A Probabilistic 3-D Short-Term Slope Stability Model
A probabilistic model to analyze the three-dimensional stability of earth slopes under short-term conditions is presented. An actual failure case is studied to show the implementation...
Simulation with Ordered Discrete-Stochastic Samples
In order to account for the viscoplastic deformations, leading to the failure of structures, the nonlinear dynamic responses can be obtained with convenient spatially discretization schemes....
Return to search