Sampling and Testing in Stiff Crustal Clays
In desiccated clays, the secondary structure consisting of fissures and slickensides greatly influence the measurement of soil strength. In a sampling study, such soils were found to be...
Mechanics of Crack Propagation in Stiff Clays
Many stiff clays forming part of natural slopes and earth dams exist in the fissured state. When these cracks are subjected to gravity induced normal and shear stresses they may propagate....
Shear Mobilization on Laterally Loaded Shafts
From the results of a pressure cell instrumented rigid shaft embedded in stiff clay and subjected to horizontal static loading the side shear mobilization rate, and its contribution to...
Nonlinear Behavior of Precast Concrete Shear Walls under Simulated Earthquake Loading
This paper presents experimental and analytical results on precast concrete shear walls under earthquake loading. It was observed in both small scale models tested and the computer analysis...
Behaviour of Full-Scale Reinforced Concrete Structure on Realistic Foundation
A full-scale seven-story reinforced concrete building, tested as a part of U. S. -Japan Cooperative Research Program, performed well even under a severe earthquake loading condition. Nonlinear...
Flexural Behavior of Reinforced Masonry Walls and Beams
Many reinforced masonry walls and beams were tested as a part of the U. S. -Japan cooperative research program on masonry building structures. Six concrete block and two clay brick masonry...
Effect of Seismic Wave Inclination on Structural Response
A new procedure is developed using the computer program SASSI to evaluate the effects of inclined propagating shear waves on three-dimensional seismic soil-structure interaction (SSI)...
The Atlantic Palace: Part I Structural System Selection Based on Wind Tunnel Testing
The location of the structure in a coastal area susceptible to high winds, the irregular shape and height of the building and the desire for more accurate wind loading and acceleration...
Dynamic Response Correlation Using Simplified Models
A simplified model for building response which has a W. Ramberg-W. R. Osgood hysteresis is developed in a discrete sense. It is then used to evaluate the response of an instrumented, bearing...
Innovative Bulkhead Design: Third Port Project?St. Croix, U.S. Virgin Islands
This paper describes an innovative design making use of a 'master pile' bulkhead to support the waterside rail for travelling container cranes as well as to retain...
Expansion of the Electro-Coal Transfer Terminal
This paper briefly describes renovation and expansion of the coal and phosphate marine terminal in Davant, La. The program included: replacement of existing berths damaged by marine accident;...
Notes on Geotechnical Input to the Design of Graving Drydocks
These notes discuss geotechnical considerations in the design of graving drydocks, in particular the floors and walls of the structure. The effect of ground-water conditions in the design,...
Rehabilitation of Gravity Wharf by Underpinning
The Municipal Wharf at the Port of Providence, Rhode Island, is currently under rehabilitation to accommodate modern trends in marine cargo handling and shipping. The three-phased project...
Geotechnical Aspects of Stiff and Hard Clays
This publication contains articles that deal with field and laboratory measurements of engineering properties of stiff (overconsolidated) clays, and comparisons of predicted and measured...
Use of In Situ Tests for Foundation Design on Clay
Years of evaluated experience with the field vane test in soft clays have resulted in empirical correction factors well suited for design practice. An extension of L. Bjerrum's...
Seismic Cone Penetration Test
A new test, called the seismic cone penetration test (SCPT) is described. A small rugged velocity seismometer has been incorporated into an electronic cone penetrometer. The combination...
Borehole Shear Test and Slope Stability
Three Iowa landslides analyzed on the basis of Borehole Shear Test (BST) data are reported. The soils included CL and ML loess and glacial till, and CH clay shale. Back-calculations from...
Pressuremeter Correlations for Preconsolidated Clay
Conventional triaxial compression and consolidation tests are often utilized to obtain parameters for design of foundations. More recently, Menard pressuremeter test results have been...
Comparison of the SPT,CPT, SV and Electrical Methods of Evaluating Earthquake Induced Liquefaction Susceptibility in Ying Kou City During the Haicheng Earthquake
The capability of SPT, CPT, Shear Wave Velocity and Electrical methods to evaluate earthquake induced liquefaction susceptibility of soil deposits consisting of sensitive clayey silts...
ECPT Investigation of a Slurry Trench Cutoff Wall
ECPT (electronic cone penetration testing) was used to investigate a soil-bentonite backfilled slurry trench cutoff wall at Calamus Dam in Nebraska, The wall was tested shortly after its...
Return to search