Stiffness of Low Rise Reinforced Concrete Shear Walls
This report, Stiffness of Low Rise Reinforced Concrete Shear Walls, was prepared by the Working Group on the Stiffness of Concrete Shear Wall...

Infrastructure
New Materials and Methods of Repair
This proceedings, Infrastructure: A New Materials and Methods of Repair, contains 146 papers presented at the Third Materials Engineering Conference...

Seismic Retrofitting: Spending to Save
Seismic retrofitting work is most often concerned with saving lives. But in cases of infrastructure, or historic structures, saving the structure, and making sure that it can operate after...

Technical Note: STC-40 Shotcrete Adhesion In Situ Tester
It is essential that the shotcrete when reinforcing the rock mass achieves a good adhesive bond to the rock surface. The strength of that bond can be controlled by pull out testing either...

Austrian Guideline and National Report on the Use of Shotcrete
The purpose of this guideline is the standardization of quality and a uniform procedure for the production and testing of shotcrete from the technical and engineering point of view. In...

The Influence of Water Glass on the Technological Parameters of Shotcrete
Shotcrete used in tunneling must follow a clearly defined early strength development in order to comply with stresses from rock deformations and drilling and blasting. Accelerators are...

Shotcrete Tests at the Fish Ecca Tunnel
The Fish-Ecca Tunnel is situated in the Eastern Cape and forms part of the Lower Fish Irrigation Scheme. About 25% of the 5032 m tunnel had to be lined with shotcrete. Between February...

An Identity Chart for Steel Fibers
Improvements in ductility and toughness by adding steel fibers to the shotcrete mix are sufficient to enable steel fibers to be used as replacement for steel mesh reinforcements. Steel...

Fire Testing of Shotcrete Samples in a Small Furnace
The fire resistance behaviour of 8 shotcrete samples were investigated in a laboratory furnace applying ISO 834 standard test. Shotcrete was applied on 20 to 30 cm thick granite slabs...

Analysis of Vessel and Vehicle Queues at Moveable Bridges
This paper describes procedures and the analysis developed to evaluate three different replacement options for the existing S.E. 17th Street Causeway moveable bridge which crosses the...

Estimating Load Impacts on Highway Structures Using the National Bridge Inventory Database
The issuance of single and multiple permits to operate vehicles exceeding legal weight limits, along with the policy-level analysis of bridge impacts induced by changes in vehicle size...

An Integrated System for Evaluation, Rating and Management of Bridges
This paper describes a software system that can effectively be used in bridge management and planning. The system integrates several modules each capable of conducting a specific task...

Regulatory Views on Seismic and Fault-Displacement Parameters Needed for a Geologic Repository Design
This paper presents the regulatory views of the U.S. Nuclear Regulatory Commission staff on some of the significant issues related to the seismic and faulting design of a geologic repository....

An Overview of Analysis and Regulatory Needs to Determine Seismic Loads for Design of a High-Level Waste Geologic Repository
Determination of seismic loads and faulting hazard for siting, design and performance evaluation of a high-level nuclear waste repository facility can be accomplished with state-of-knowledge...

Performance Goal Based Seismic Design Criteria for High Level Waste Repository Facilities
This paper proposes a set of deterministic seismic design and evaluation criteria based upon a specified probabilistic seismic performance goal for High Level Waste Repository (HLWR) facilities....

Probabilistic Analysis of Faulting Associated with Earthquakes for Nuclear Waste Repositories
The probabilistic analysis of seismogenic faulting follows the same general methodology as the more common seismic hazard analysis for shaking. The main difference lies in the influence...

Tectonic Characterization of a Potential High-Level Nuclear Waste Repository at Yucca Mountain, Nevada
Tectonic characterization of a potential high-level nuclear waste repository at Yucca Mountain, Nevada, is needed to assess seismic and possible volcanic hazards that could affect the...

Geometric Models of Faulting at Yucca Mountain
Yucca Mountain, Nevada, is currently being studied as a potential site for a geologic repository of high-level radioactive waste. Alternative conceptual tectonic models are expected to...

Factors Controlling Strong Ground Motion and Their Associated Uncertainties
Of special interest in strong ground motion modeling is a quantification of the degree of influence specific physical parameters have on the computed motions. Associated with the model...

Preliminary Report: The Little Skull Mountain Earthquake, June 29, 1992
The Little Skull Mountain earthquake occurred about 20 km from the potential high level nuclear repository at Yucca Mountain. The magnitude was 5.6, and the focal mechanism indicates normal...

 

 

 

 

Return to search