Learning from Failures: Procedural Changes in the Design and Construction Process to Reduce Failures
This paper first defines failures and their number and scope in the design and construction fields. It then presents the writer's opinion as to the cause of the failures and...
Failure Investigations in Undergraduate Education
Author stresses the need for failure investigations in undergraduate education especially in Civil Engineering. The civil engineer often creates only one major project of a kind, and is...
Type C Fly Ash and Clay Stabilization
Because the soils onsite have a high swell potential, a 37 foot high retaining wall was designed with counterforts and was supported by pier foundations to limestone. In order to reduce...
Building Condition Assessment�An Owner's Perspective
The Port Authority of New York and New Jersey has recently instituted a program to inspect all of its buildings structures to insure structural integrity and public safety and to provide...
Evaluation and Modernization of Veterans Administration Facilitaties
This paper discusses two examples showing in detail that procedures for building assessment require much consideration for engineers' programming and must be properly specified...
Changing Priorities in UK Construction Research
This paper addresses two types of situations to contend with in building assessment: aging structures all built at about the same time and to standards no longer acceptable, and newer...
Research Needs for Extant Iron and Steel Buildings
A brief review of iron- and steel-making processes is background for the development of shapes and codes. Sources of information for the condition assessment of iron and steel buildings...
Structural Integrity Assessment of the Flexible 870 Advanced Design Bus
The Grumman Flxible 870, a lightweight advanced design urban bus, entered service in Atlanta, GA in 1978, and some 2,800 of these buses were in service nationwide by 1980. In the autumn...
Prestress and Cracking Problems in Concrete Structural Components of an Elevated Rail Transit Guideway System
In 1983 the Department of Transportation evaluated the quality of construction of selected structural components on the Dade County Transportation Administration METRORAIL elevated guideways....
Damage Tolerance Assessment of Commercial Airframes
The regulatory authorities now require that commercial transport aircraft structural design be based on a damage tolerance philosophy. A brief history of the development of the regulations...
Continuum Modeling of Periodic Truss Structures
Procedures for deriving equivalent stiffnesses for an extended Timoshenko beam used to represent truss beams are presented. A typical substructure of a truss is used to calculate these...
Continuum Modeling of Discrete Structures with Geometric Nonlinearities
The modeling of geometrically non-linear discrete structures by an equivalent continuum is presented. The discrete-continuum analogy is developed by first isolating a unit cell of the...
General Continuum Models for Discrete Structures
New knowledge is presented about the structural behavior of a variety of large repetitive lattice configurations of the type appropriate for utilization in cosmic space. Focus is placed...
Use of Computer Graphics in the Analysis of Large Space Structures
This paper illustrates how interactive computer graphics can provide a useful tool in setting up analytical models of structural latticeworks comprised of large numbers of degrees of freedom...
Damage Detection in Periodic Structures
Nondestructive damage detection in periodic structures using continuum analogues of the discrete structure is studied. Algebraic equations relating changes in eigenfrequencies to the fractional...
On Cyclic Testing with Thin Long Hollow Cylinders
The hollow cylinder device has emerged in recent years as an important tool in the investigation of the dynamic behavior of soils. This paper reviews the stress conditions present in the...
Aspects of Constant Volume Cyclic Simple Shear
Data from cyclic simple shear tests comprise the foundation on which rests most of the practical applications of theoretical soil dynamics. The importance of the test derived from two...
Centrifuge Model Testing with Dynamic and Cyclic Loads
This paper examines the use of small-scale tests on centrifuges to study a wide range of problems in soil dynamics - including machine foundations, structures and explosion effects. The...
Uplift Behavior of Shallow Soil Anchors?An Overview
An overview is presented of the static uplift (tensile) behavior of shallow anchors used for foundations in soil. Basic anchor types are described, and their general installation and behavioral...
Uplift Capacity of Shallow Offshore Foundations
Soil failure under upward loading is investigated by experimental laboratory tests. The problem of uplift capacity is considered in terms of effective stresses in soil skeleton and pore...
Return to search