Design of Built Up Compression Members for Long Span Bridge Structures
This paper discusses the design of built up compression members for long span bridge structures including trusses and arches. Provisions of load factor design and use of high strength...

Analysis of the Seismic Records of a Suspension Bridge
A well-instrumented suspension bridge in Los Angeles, was shaken by the October 1, 1987 Whittier earthquake (ML = 5.9). This study addresses the...

Vibration and Impact in Skewed Steel Bridges
The vibration and impact of skewed multigirder bridges due to vehicles moving across rough bridge deck are studied. The bridges are modeled as grillage beam systems. The vehicle is simulated...

Ambient Vibration Response of a Long Span Bridge
Natural frequencies, mode shapes and damping characteristics for a long-span cable-stayed bridge were experimentally determined from a series of ambient vibration tests for both the cantilever...

Instrumentation Considerations for Nondestructive and Destructive Testing of Reinforced Concrete Slab Bridges
This paper examines the process of selection and calibration for instruments used in nondestructive and destructive field tests of a reinforced concrete slab bridge. Of great importance...

Magnetic Flux Leakage for Bridge Inspection
For many years the Federal Highway Administration and before that the Bureau of Public Roads had focused its nondestructive evaluation program on development of better tools to inspect...

Remote Monitoring of a Stressed Timber Bridge Deck
The long term behavior of a CCA treated stressed timber deck bridge is being monitored, at present, using a remote data acquisition system. The bridge which is located in Gray, Maine was...

Performance Monitoring of Concrete Structures with Embedded Sensors
This paper describes the use of embedded fiber optic sensors to monitor the performance of reinforced concrete structures. The fiber optic sensors are capable of measuring vibrations,...

Monitoring Performance of Full Scale Structures
General Physics Services Corporation (GPSC) of Columbia, Maryland has developed a device for the remote long-term monitoring of full scale structures, such as highway bridges. This patented...

Full Scale Dynamic Monitoring of Highway Bridges
Sensitivity of identified modal properties by physical testing is critical for automated monitoring of bridge structural condition. It is investigated here considering flexure modes and...

Coolidge Dam Abutment Stability and Stabilization
This paper focuses on left abutment stability assessments and stabilization measures at Coolidge Dam, Arizona. Initial assessment of abutment stability was based on limited rock strength...

Supply-Side Solutions
Although the crumbling bridge infrastructure has received much attention in the press and the engineering community over the past few years, the number of structurally deficient bridges...

Marginal Overweight Operating Scenario for DOE's Initiative I Highway Casks
This paper assesses the potential transport of high-capacity Initiative I highway casks under development by the Office of Civilian Radioactive Waste Management (OCRWM) as permitted marginal...

Alternatives Analysis Using Two-Dimensional Modeling for the Owensboro Bridge and Approaches
The Federal Highway Administration plans to design and construct a new bridge over the Ohio River near Owensboro Kentucky. A hydraulic model with two-dimensional capabilities was utilized....

A Structural Analysis System for Prestressed Concrete Bridges and its Application on the Interurban Express-Way Project in SEOUL
In this paper, the importance of the structural analysis in accordance with the construction progress was emphasized to accurately predict the structural behavior of prestressed concrete...

Computer Analysis of Cable-Stayed & Suspension Bridges
The finite element structural analysis of long span bridges is an area of research that has been studied within the past thirty years since the development and emergence of the digital...

Modeling Beam Torsion in Prestressed Concrete Box Beam Bridges
This paper briefly summarizes the development of a specialized finite element model capable of predicting the elastic and inelastic behavior of beam-slab type prestressed concrete spread...

Time-Dependent Nonlinear Analysis of Cable-Supported Prestressed Concrete Bridges
A method of analysis and a computer program CFRAME for the material and geometric nonlinear analysis of cable-supported planar prestressed concrete bridges including the time-dependent...

Finite Element Analysis and Design of Bridges with Applicatrons of ICAD
This paper describes applications of client-server models, interprocess communications (IPC), and concepts of intelligent CAD (ICAD) to the interactive design and analysis of highway bridge...

Effect of the Periodic Secondary Irregularity on the Dynamic Behaviour of Railway Bridge-Vehicle System
The deformation and vibration of bridge will be developed due to the moving vehicles, especially for railway bridge. The dynamic deflections in the points under each wheel are called secondary...

 

 

 

 

Return to search