Behavior of Drilled Piers in Layered Soils on Texas Barrier Islands
Twenty-eight full scale load tests and the results of 41 geotechnical studies were analyzed to correlate shear strength interpreted from field and laboratory test data with those derived...
Landslide Hazard Rating for the Oregon Coast Range
The landslide hazard rating system for shallow soils on steep terrain over hard sandstone has three components: ground water response to precipitation, soil shear strength (including root...
Abutment Seepage at Smithville Dam
After initial filling there was concern for the stability of Smithville Dam when higher than anticipated piezometric levels were experienced in the left abutment foundation. Concern heightened...
Application of a Three-Dimensional Coupled Finite Element?Boundary Element Method
Three-dimensional conditions in underground construction occur at the face of a tunnel, at intersections of underground openings and around roughly equidimensional openings. As long as...
Bond Stress of Embedded Steel Shapes in Concrete
This paper describes an investigation into the bond stress developed between steel shapes and reinforced concrete when the concrete is lightly stressed. A brief discussion of previous...
Shear Strengths of Concrete-Filled Steel Box Elements
This study evaluated the ultimate strengths as well as the effect of the ultimate composite actions of concrete-filled steel composites under combined bending, shear, and axial forces....
Composite Columns?Design and Examples for Construction
The new German standard DIN 18806, part 1 gives the rules for the design of composite columns. The general method, taking into account all the inhomogeneties of the two materials steel...
Design of Framed Steel Structures with Infill Reinforced Concrete Walls
It is a well-known fact that an infill shear wall in a frame acts as a compressive diagonal strut, giving strength and inflexibility to the frame. Recently the Architectural Institute...
Simultaneous Withdrawal of Saline/Fresh Waters in a Stratified Aquifer
The objective of this study is to develop computational tools for simulating the flow behavior of an aquifer in response to simultaneous pumping of two stratified fluids from both sides...
Coastal Erosion Management in Australia and the U.S.
Current knowledge and management policies in both Australia and the U. S. favor non-structural over structural responses to coastal erosion problems wherever possible. The trend towards...
Measurement and Use of Shear Wave Velocity for Evaluating Dynamic Soil Properties
Geotechnical engineers have recognized in the past decade that shear wave velocity is a basic soil property and have begun to use it to characterize sites for many uses. Most notable has...
Staggered Truss Adapted to High Rise
The 34-floor Nashville Convention Center Hotel required a structural system that would overcome the tendency to vibrate in the wind. The solution was a modified staggered frame truss,...
Modeling Boundary Layer Flow in Stormwater Detention Basins
An iterative procedure involving an implicit finite difference numerical scheme was implemented on an IBM personal computer for solving steady, uniform and nonuniform boundary layer flow...
Friction in Hurricane Induced Surges
Bed shear stresses induced by the flowing water are expressed by means of a friction factor for which formulas are developed for: ocean bottom, mangrove fringes and areas, forested areas...
Modeling Hydraulic Problems Using the CVBEM and the Microcomputer
The Complex Variable Boundary Element Method (CVBEM) offers an effective and efficient means for modeling two-dimensional potential and related flow problems. The method has been applied...
Boundary Shear Stress in a Meandering Channel
Longitudinal and transverse velocity, bed shear, and water surface elevation were studied in a fixed-bed, meandering, laboratory channel with naturally varying, non-prismatic cross sectional...
Three-Dimensional Simulation of Two-Fluid Movement in Porous Media Using the Boundary Element Method
The paper discusses three-dimensional problems that include a denser fluid overlain by water in an unconfined aquifer. The two fluid regions are bounded by two-dimensional surfaces, including...
Generation of Steady Density Currents Through Boundary Layer Control
The paper reports on a study to explore the conditions that trigger bifurcation of ambient flow/intrusion interaction into one of two drastically different regimes, i. e. current versus...
Nonlinear Macroscopic Finite Element Model for Masonry Walls
A macroscopic finite element model which includes both transverse shear effects and nonlinearity due to cracking has been developed for masonry. These features are accommodated using a...
Shear Design of Masonry Walls
The paper presents a summary of a research project carried out at the Swiss Federal Institute of Technology Zurich to develop a design method based on the ultimate strength of masonry...
Return to search