Movement of Nonaqueous Liquids in Groundwater
Evidence from field sites indicates that when nonaqueous liquids, such as organic solvents and gasoline, are released into the subsurface environment they tend to remain as a separate...

Assessment of Pore Fluid Effects Using Flexible Wall and Consolidation Permeameters
Hydraulic conductivity tests were conducted on compacted soil specimens prepared at activities of 0. 36, 0. 60, 1. 00 and 1. 39 at a fine fraction of 25 percent. Na-montmorillonite, Georgia...

Containment of Low-Level Radioactive Material
The U. S. Department of Energy has completed a short term storage site for the containment of low-level radioactive residues and contaminated soil near Lewiston, New York. The site, known...

Landfill Stabilization for Structural Purposes
The insitu stabilization of landfills and waste disposal sites for structural and environmental purposes has recently been accomplished through the application of existing soil stabilization...

Erosion of the Slopes of Gold Tailings Dams
A study has been made of rates of erosion from the slopes of gold-residue dams in the South African Highveld region. Data is available for two years at this time and conclusions must therefore...

Stabilized Fly Ash for Use as Low-Permeability Barriers
Two class F fly ashes from power stations located in West Virginia were stabilized by adding various percentages (by weight) of either lime or cement. Test specimens were subjected to...

Effect of Permeameter and Leachate on a Clay Liner
Hydraulic conductivity tests were performed on a natural clay liner material using leachate from an active Type II landfill. Comparative tests were conducted using flexible wall permeameters,...

Environmental Geotechnology & Tailings Reclamation
The Department of Energy is responsible, in terms of Federal Legislation, for remedial action work at 24 inactive uranium mill tailings piles in ten states. This paper describes the setting...

Reclamation of Athabasca Oil Sand Sludge
The bulk of oil sand tailings (80 to 90%) consists of quartz sand, which is defined to be everything coarser than 44 microns. The other 10 to 20%, termed 'sludge',...

Flow and Mass Transport for Hazardous Waste Liners
Certain aspects of flow and contaminant migration of hazardous liquids through soils are addressed. A fine-grained soil and fluids commonly encountered in hazardous sites, were considered....

Field Measurements of Landfill Surface Settlements
The Collier Road Landfill, located in southeast Michigan, has been accepting industrial and muncipal solid waste since the late 1960's. This existing landfill encompasses...

Analysis of Plastic Soil in Contact with Cavitose Bedrock
A numerical analysis has been conducted to evaluate the stress deformational response of highly plastic soils in contact with cavitose Bedrock. The numerical idealization represents the...

Hazardous Waste Landfill Cap System Stability
Pursuant to the regulatory requirements for control of rainfall infiltration into a hazardous waste landfill, a cap design that is impervious plus stable is required. The intent of a cap...

Fly Ash as a Potential Waste Liner
Earthen liners have been widely used to contain toxic and hazardous materials in ponds and landfills. There is close scrutiny over the durability of liners in contact with various wastes...

Test Fill for a Double Liner System
A double liner system is required in hazardous waste disposal facilities to satisfy the current Resource Conservation and Recovery Act and State of Michigan Act 64 Requirements. To meet...

Quality Control Testing for a Sand-Bentonite Liner
This paper presents the results of the quality control testing performed during the construction of a sand-bentonite liner for a sanitary landfill site in Central Florida. The available...

Design and Performance Monitoring of Clay-Lined Landfills
The use of thick clay liners has been applied to Wisconsin landfills for over a decade. Currently, there are over 35 solid waste disposal facilities in Wisconsin which have been constructed...

Acceptance Sampling for Clay Liner Design
The assurance of the quality of constructed clay liners has been a problem for geotechnical engineers. Compliance with minimum standards is necessary to ensure the liner performance capability....

Influential Factors in Soil Liner Construction for Waste Disposal Facilities
Those factors most influential in the construction of a soil liner to meet a permeability performance standard of 1 multiplied by 10-7 centimeters per second (cm/sec) are identified and...

Automated Permit Review for Hazardous Waste Surface Impoundments
The United States Environmental Protection Agency has proposed to develop automated permit review for RCRA hazardous waste surface impoundment facilities. The review automation will consist...

 

 

 

 

Return to search