Significance of Yield Surface Corner-Like Effects in Inelastic Stability Solutions
This paper presents the author's experiences with finite element prediction of the inelastic stability of steel plate structures. The implications of linear versus nonlinear...

Bibliography of Steel Columns
This book, which was prepared by the Committee on Compression Members of the Structural Division of the American Society of Civil Engineers, attempts to provide a complete bibliography...

Grouting Slip Liners: The New Inside Story
There are approximately 800,000 miles of water and sewer pipelines in the U.S. that need remedial work. About 2% need work each year, usually due to normal or accidental corrosion. Normal...

Future Freight
In 21st-century America, most long-distance cargo will be transported via pipelines linking major cities. The most versatile freight pipeline is the capsule variety, which carries cargo...

Changes in Tubular Design Codes
This paper summarizes a number of changes in design provisions for tubular structures that have recently been adopted. These are the result of a number of research advances concerning...

An Optimal Design of Steel Pipe Pile Foundation
This paper presents an optimal design method for the steel pipe pile foundation of bridge pier using a nonlinear programming. It is firstly assumed that an imaginary wall model behaves...

Numerical Evaluation of Energy Release Rates
Numerical studies are described that evaluate the total energy release rate, GT, for quasi-static, Mode I cracks using two-dimensional finite-element...

Fiberglas Reinforced Plastic Rebars in Lieu of Steel Rebars
Fiberglass reinforced plastics have recently been introduced in the market in the form of rebars for concrete reinforcement. The light weight, corrosion resistance and non-magnetic properties...

The Fatigue Performance of Welded Joints in a Marine Environment
The fatigue lives of plate-plate, pipe-plate, and tubular welded joints tested in seawater under free corrosion, optimum cathodic protection and cathodic overprotection measured in the...

Effect of Temperature on the Load-Carrying Capacity of Fiber Glass Reinforced Plastic Beams
This paper describes an experimental investigation into the behavior of two T shaped beams made of fiber glass reinforcement and polyester or vinylester binders. Tests were performed at...

Verification of Macroscopic Models for R/C Walls
Macroscopic models utilized in a plastic analysis for predicting the ultimate strength of reinforced concrete members have been developed in Japan as well as in Europe. In the JCI committee,...

Inelastic Response of Buried Pipelines Due to Landslide Effects
During earthquakes, a buried pipeline may experience significant loading as a result of large relative displacements of the ground along its length. Large ground movements can be caused...

Earthquake Resistant Design Using Friction Pendulum Connections
The Friction Pendulum System (FPS) offers a simple approach for increasing a structure's earthquake resistance. The approach uses steel connections which absorb earthquake...

Buckling Criteria for Earthquake-Induced Overturning Stresses in Cylindrical Liquid Storage Tanks
Perhaps one of the most common forms of seismic damage to cylindrical liquid storage tanks made out of steel is buckling of the tank wall due to vertical overturning stresses. Buckling...

Development of Inelastic Reduction Factors to Provide an Elastic Design Procedure
R factor values can only be rationally selected when they are based on in part nonlinear inelastic dynamic analyses of building system types. However, it is informative to discuss the...

An Evaluation of Pile Design in Fraser River Delta Using In-Situ Tests
Modern methods of pile design often take advantage of in-situ test data. Thirteen axial pile capacity design methods have been evaluated using the results from eight full-scale pile load...

Ultimate Capacity of Deep Foundation by a Rigid-Plastic Analysis
This paper is concerned with the determination of the axial ultimate capacity of a rigid pier on the basis of the theory of perfect plasticity. As an application of the upper bound theorem...

Analysis of Pile Load Tests at Lock and Dam 26
This is a summary of the results collected during the extensive load test program performed by the U.S. Army Engineer District, St. Louis, during the construction of the new Lock and Dam...

Interpretation of Instrumented Driven Steel Pipe Piles
This paper presents the results of a series of studies on the behavior of driven close-ended steel pipe piles. Extensive field explorations and geotechnical analyses have been carried...

Cost Effective Pile Foundation Supports Fast Track Paper Mill
This paper decribes the generalized subsurface conditions, pile evaluation and load test program, pile and piling contractor selection, production pile installation, and quality assurance...

 

 

 

 

Return to search