Borehole Shear Test and Slope Stability
Three Iowa landslides analyzed on the basis of Borehole Shear Test (BST) data are reported. The soils included CL and ML loess and glacial till, and CH clay shale. Back-calculations from...
Pressuremeter Correlations for Preconsolidated Clay
Conventional triaxial compression and consolidation tests are often utilized to obtain parameters for design of foundations. More recently, Menard pressuremeter test results have been...
Comparison of the SPT,CPT, SV and Electrical Methods of Evaluating Earthquake Induced Liquefaction Susceptibility in Ying Kou City During the Haicheng Earthquake
The capability of SPT, CPT, Shear Wave Velocity and Electrical methods to evaluate earthquake induced liquefaction susceptibility of soil deposits consisting of sensitive clayey silts...
In Situ Tests Aid Design of a Cylinder Pile Wall
In situ testing was used to verify geotechnical design parameters and modify construction for a 22 million dollar slope stabilization project near a major highway interchange. The project...
Correlation of Soil Parameters From In Situ and Laboratory Tests for Building 333
Pressuremeter, plate bearing and cone penetration tests were performed on the prepared foundation soil for Building 333 located in the Red River Army Depot near Texarkana, TX. The results...
Pore Pressure Effects in Borehole Shear Testing
The effects of excess pore pressures on shear strength results obtained using the Borehole Shear Test (BST) were investigated. Pore pressures were measured during the consolidation, shear,...
The Mudslide Profile Method to Measure the Undrained Shear Strength of Muds
Mudslides have been reported to have a very distinctive profile. Using this distinctive profile, a method is presented to analyze the stability of the mudslide at limit equilibrium conditions....
Vane Shear Testing for Staged Construction
Staged construction was used for the earthfill embankment of Birch Dam in order to compensate for low strength clays in the foundation. Sampling and testing of foundation soils verified...
Analysis of Liquefaction Potential by Insitu Testing
This paper describes the results of insitu testing performed to assess the liquefaction potential of a sand formation at a site for a proposed large industrial facility in East Central...
Effctive Stress Interpretation of In-situ Tests
Significant differences in terms of load-settlement curves obtained from Plate Load Tests (PLT) and q//c profiles obtained from Static Cone Penetration Tests (SCPT) at two sites with different...
Fast, Economical, Cone Testing of River Sediments
The objective of the study reported was to obtain quantitative geotechnical information over many square miles of Hudson River bottom. A hand held cone penetrometer was selected for use....
In Situ P and S Wave Velocity Measurement
A review of the in situ techniques to measure P and S wave velocities by seismic wave propagation is presented. A relatively new technique, the suspension PS logging method, is described...
In Situ Tests for Foundation Vibrations
There are several well established methods of determining shear modulus in situ and these are summarized in this paper. New techniques are being developed for in situ determination of...
In Situ Tests on a Florida Peat
A geotechnical exploration program at a site predominated by surface peats has been performed. The study encompasses the performance of in situ field tests and laboratory soil tests. Field...
Effect of Particle Size on Sludge Dewaterability
Using a modified Buchner funnel apparatus to measure specific resistance and a sequential centrifugation/filtration procedure to fractionate a sludge, it was possible to more precisely...
An Evaluation of Sediment Resuspension Parameterizations
The recent attention to managing surface water toxic substances has resulted in a number of modeling approaches, all of which to a great or lesser extent require accurate treatment of...
Effect of the Fluid Velocity on the Biofilm Development
In order to get basic information concerning the application of a biological treatment to the ammonia nitrogen removal from drinking water, we considered the relation between the biofilm...
Physical Habitat Simulation and the Moveable Bed
One objective of an instream flow analysis is to quantify a flow that will maintain the existing channel and/or flush fine material from the bed. Five empirical approaches to determine...
Application of the BEM to Elastodynamics in a Three Dimmensional Half Space
The boundary integral equations (BIEs) are formulated for scattering problems of elastic waves by a cavity or a crack in a three dimensional half space. Two formulations based on the Green's...
Explicit Integration of Boundary Integral Equations in the Frequency Domain for Wave Scattering Problems
The goals of this article are: (1) to present an efficient method for the integration of the boundary integral equations for wave scattering problems and (2) to apply this method to the...
Return to search