Seismic Strengthening of Johnstown Tank in Lakeside, California
Seismic overturning moments exerted on liquid storage tanks may be resisted by a system of anchor bolts if the shell could be adequately anchored to its base, or by allowing the base plate...
Buckling of Cylindrical Storage Tanks Due to Unsymmetric Lateral Wind Load
Non-linear finite element analysis is used to study the elastic stability of cylindrical storage tanks subjected to unsymmetrical loads. These cylindrical shells are assumed to be fixed...
Hanford Waste Vitrification Project Overview and Status
The Hanford Waste Vitrification Project (HWVP) is being constructed at the U.S. Department of Energy's Hanford Site in Richland, Washington. The paper gives an overview of the HWVP which...
Simulated Hanford Waste: A Study of Physical Properties, Gas Retention, and Gas Generation
This study helps to establish the physical and chemical processes responsible for the generation and retention of gases within high-level waste contained in Tank 101-SY on the Hanford...
Wave Boundary Layer Above the Submerged Coastal Slope
A calculation method of parameters of turbulent boundary layer formed by waves is proposed. A calculation of boundary layer on a rough slope with inclination typical for steep Caucasian...
Runoff Prediction by Recession Curves
Based on the characteristics of the discharge hydrograph such as the rising limb and the recession curve, a simple water tank model is constructed. This water tank has cross-sectional...
Cylindrical Shell Redesign by Large Admissible Perturbations
Redesign (or inverse design) is the problem of defining an objective structural State S2 from its specifications and the known baseline State S1. The large admissible perturbations approach...
Dynamic Stability of Composite-Material Circular Cylindrical Shells with Orthogonal Stiffeners
The governing equations are formulated for general (axisymmetric or unsymmetric) vibrations of thin circular cylindrical shells of composite material and reinforced with axial (stringer)...
Finite Element Large Deflection Analysis of Cylindrical Shells with Different Types of Cutouts
Nonlinear finite element is used to find the elastic buckling load and the maximum deflection for cylindrical shells subjected to unsymmetrical pressures due to wind. These shells are...
Wave Exciting Forces on a Platform Fixed in Nonlinear Shallow Water Waves
This paper presents the result of an experimental observation of cnoidal waves and the nonlinear wave loads on a fixed barge in a 2-dimensional wave tank. The Ursell numbers of the waves...
U.S. Sludge Digesters: From Pancakes to Eggs
Egg-shaped anaerobic sludge digesters, used extensively in Germany and Japan, cost more to build, but provide better mixing of sludge, require less maintenance and less energy to operate,...
Failure Modes of Flat Bottom Vertical Storage Tanks
Flat bottom vertical storage tanks are important components in essential nuclear power plant safety systems. Data on the seismic capacity and failure modes of such tanks have been identified,...
A Comparison of Two Large Scale NLP Strategies for Determining Optimal Pump Station Controls
To solve the general nonlinear problem which is not simplified using the uniform spatial demand patterns, a two-level hierarchial scheme has been identified. The purpose of this decomposition...
Reactivation of the Oil and Hazardous Materials Simulated Environmental Test Tank (OHMSETT) Facility
The Oil and Hazardous Materials Simulated Environmental Test Tank (OHMSETT) was run by the Environmental Protection Agency (EPA) from 1974 to 1988. This open-air tank was used to test...
Results from Selected Oil-Spill Response Research
Recent large oil spills from tankers have reaffirmed the need for continuing technology assessment and research to improve oil-spill response capabilities. The Minerals Management Service...
Phased Engineering Development and Multiple Agency Review of Public Safety Issues
Several Santa Barbara County agencies have key engineering review responsibilities for new development. The magnitude of issues raised and the level of engineering review required for...
Evaluation of Beach Erosion and Accretion Predictors
This paper examines the capability of simple criteria to predict whether a beach will erode or accrete by wave-induced cross-shore sand transport. Emphasis is on beach change of engineering...
Large, Monolithic, Weighing Lysimeters
Monolithic lysimeters preserve existing vegetation and soil properties that can be destroyed by excavation and filling. Site preparation for constructing large, monolithic lysimeters includes...
Precision Lysimetry in France
After a definition of the parameters to be measured, a possible reasoning is presented for the construction of a weighing lysimeter. A number of factors have to be taken in account: the...
Direct Load Cell-Based Weighing Lysimeter System
A low-cost weighing lysimeter system is described which is capable of measuring evapotranspiration with an accuracy of 0.05-0.10 mm. A two-lysimeter system with electronic data logger...
Return to search