Development of High Strength Composite Cables
Fiber reinforced composite materials offer significant advantages over conventional materials, for such factors as corrosion resistance, lighter weight, and higher strengths. These advantages...
Compressive Deterioration of Cracked Concrete
When shear behavior of reinforced concrete (R/C) members is to be simulated, the compressive strength and the stiffness reduction of cracked concrete must be taken into consideration....
Ultimate Strength and Deformation of RC Panels
In this study, twenty reinforced concrete panels have been tested under pure shear. Test results showed that the compressive strength of concrete strut was strongly affected by bond characteristics...
Shear Strength of P.P.C. Beams
50 beams of partially prestressed concrete were tested and 82 data of the ultimate shear-strength were obtained. Based on these results, this paper studies the effects of the degree of...
Macroscopic Models for R/C Shear Walls
In this paper, the discussion is mainly focused on four macroscopic models, recently proposed by Japanese researchers, for predicting ultimate strength of reinforced concrete (R/C) shear...
Verification of Macroscopic Models for R/C Walls
Macroscopic models utilized in a plastic analysis for predicting the ultimate strength of reinforced concrete members have been developed in Japan as well as in Europe. In the JCI committee,...
Parametric Analyses of RC Shear Walls by FEM
In this paper, nonlinear behavior of reinforced concrete shear walls is studied by using the finite element analysis. We applied numerical analyses to a wide range of parameters, such...
Strength Evaluation of Existing Reinforced Concrete Structures
The load test as described in ACI 318-83 Chapter 20, entitled 'Strength Evaluation of Existing Structures,' was conducted at 60%, 80%, and 100% of the calculated...
Flexural Strength of Ultra-High Strength Concrete Members
Various proposals have been made for the pridiction of strength of high strength concrete sections. One of the most important parts of any strength computation procedure is the assumption...
Member Design Equations for a LRFD Wood Specification
A key step in the preparation of a load and resistance factor design (LRFD) based design specification for engineered wood construction is the selection of the behavioral equations for...
Inelastic Performance of Single-Story Masonry Shear Walls
Twenty-two story-height reinforced masonry shear walls have been tested to examine the influence of the applied axial stress, and the amount of vertical and horizontal reinforcement on...
Use of Experimental Data to Develop Probable Behavior
The intent of this paper is to present results of research that studies the performance of the University of Colorado walls tested by Professor Benson Shing. These walls would be classified...
Ductility and Failure Characteristics of Concrete and Rock Subjected to Complex Load Paths
Strength, ductility and the complex material response features of concrete and rock should be evaluated through carefully planned material properties test programs designed to subject...
A Damage Model for Reinforced Concrete
The damage index developed by the authors models concrete damage as a low-cycle fatigue phenomenon. By quantifying the energy dissipated as a fraction of the total energy dissipation capacity,...
Seismic Vulnerability and Retrofitting of Buildings. Recent Experiences in Mexico City
Measures taken in Mexico City after the 1985 earthquake to evaluate the safety of existing buildings, to strengthen damaged structures and to retrofit those that were considered to need...
Nonlinear Analysis for the Aseismic Strength of Highrise Steel Frame With Semi-Rigid Joints by Pseudo-Elastic Approach
This paper suggests that the direct stiffness method is still useful in dealing with the nonlinear analysis for the aseismic capacity of highrise steel frame while the Pseudo-elastic approach...
Amelioration of Stirrup and Compression Reinforcement on the Ductility of Reinforced High-Strength Concrete Beam
18 rectangular high strength concrete beams were tested to investigate their ductile behavior. The results show that it will be more advantageous, for ductility, to choose the compressive...
Seismic Strengthening of a Historic Unreinforced Masonry Building
The building involved is a four-story unreinforced masonry structure. Considerations related to development of design criteria are presented along with retrofitting strategies. The building...
Seismic Strengthening of a Tall Masonry Building
The design of a strengthening system for a tall building is proposed using ductile reinforced masonry shear walls. This innovative design concept produced a system that controlled the...
Recent Research on Repair and Strengthening of Reinforced Concrete Structures
As part of the research effort organized following the 1985 Mexico City earthquake, a series of tests were conducted at the University of Texas at Austin to assess the performance of redesigned...
Return to search