OTEC Seawater Pipe Cost Comparisons
Describes a material which can substantially reduce the cost of seawater pipes and two methods for building and deploying such pipes for use in land-based OTEC installations, outfall sewers,...

Brittleness of High Strength Concrete
Fracture mechanics approaches are needed to determine material parameters which are related to the brittleness of concrete and its structural response. The size effect method is used to...

Size Effect in Concrete Structures and Influence of Loading Rate
The size effect law models the influence of the dimensions of the structure or specimen on the failure stress. This model can be used to quantify the brittleness of failure, and determine...

Anomalous Structural Size Effect in Cohesive Materials Like Concrete
This contribution analyses on theoretical grounds the size effect trends in special cases where - unlike most experimental situations in fracture research - the specimen is not precracked...

Grouting Slip Liners: The New Inside Story
There are approximately 800,000 miles of water and sewer pipelines in the U.S. that need remedial work. About 2% need work each year, usually due to normal or accidental corrosion. Normal...

Future Freight
In 21st-century America, most long-distance cargo will be transported via pipelines linking major cities. The most versatile freight pipeline is the capsule variety, which carries cargo...

Changes in Tubular Design Codes
This paper summarizes a number of changes in design provisions for tubular structures that have recently been adopted. These are the result of a number of research advances concerning...

An Optimal Design of Steel Pipe Pile Foundation
This paper presents an optimal design method for the steel pipe pile foundation of bridge pier using a nonlinear programming. It is firstly assumed that an imaginary wall model behaves...

The Fatigue Performance of Welded Joints in a Marine Environment
The fatigue lives of plate-plate, pipe-plate, and tubular welded joints tested in seawater under free corrosion, optimum cathodic protection and cathodic overprotection measured in the...

Inelastic Response of Buried Pipelines Due to Landslide Effects
During earthquakes, a buried pipeline may experience significant loading as a result of large relative displacements of the ground along its length. Large ground movements can be caused...

An Evaluation of Pile Design in Fraser River Delta Using In-Situ Tests
Modern methods of pile design often take advantage of in-situ test data. Thirteen axial pile capacity design methods have been evaluated using the results from eight full-scale pile load...

Analysis of Pile Load Tests at Lock and Dam 26
This is a summary of the results collected during the extensive load test program performed by the U.S. Army Engineer District, St. Louis, during the construction of the new Lock and Dam...

Interpretation of Instrumented Driven Steel Pipe Piles
This paper presents the results of a series of studies on the behavior of driven close-ended steel pipe piles. Extensive field explorations and geotechnical analyses have been carried...

Cost Effective Pile Foundation Supports Fast Track Paper Mill
This paper decribes the generalized subsurface conditions, pile evaluation and load test program, pile and piling contractor selection, production pile installation, and quality assurance...

Innovative Foundation Designs for Permafrost Conditions in the Arctic
This paper describes the engineering solution to restore the structural properties of permafrost at a site location in the Western Operating Area of the Prudhoe Bay Field. Steel pile supports...

Surface Water Particles: Coagulation and Sorption
A size-dependent particle and particle-associated contaminant transport and fate model is presented. The unsteady, two-dimensional model couples the water column and bed and enables analysis...

Pressure Relief Design Around Pumping Plants
Hydraulic transient protection for an irrigation pipeline pump station can include optimized operating procedures, or design of surge relief equipment such as surge relief valves, and...

Locating and Sizing Air Release Valves on Irrigation Systems
This writing is directed to persons involved in irrigation systems and describes the usage of air release and vacuum valves. Principles described are applicable to many other piping systems,...

TVA: A Half-Century of Sedimentation Experience
The Tennessee Valley Authority (TVA) is a regional resource development agency, created by the United States Congress in 1933 and charged with bringing to the Tennessee River watershed...

Hydraulic Mechanisms of Riverbank Erosion
Recent efforts are described to develop an improved understanding of bank failure due to piping in noncohesive layers in riverbanks. The efforts included field surveys and laboratory tests....

 

 

 

 

Return to search