Turbulent Velocity Flutuations in Natural Rivers
The longitudinal and transverse components of flow velocity, as well as the normal and tangential stresses, must be expected to fluctuate with time and space when flow at a high Reynolds...
Determination of Pulsating Pressures for Baldhill Dam, N.D. Spillway
Model tests of the existing Baldhill Spillway were conducted with symmetrical and asymmetrical gate openings to determine for various flow conditions the characteristics of the hydraulic...
Prediction of Occurrence and Runoff Analysis of Debris Flow
A debris flow will occur on a slope when the rainfall exceeds a certain value determined by the hydraulic, geological and topographic properties of the slope. To estimate this critical...
Large-Scale Embankment Overtopping Protection Tests
The U.S. Bureau of Reclamation (Reclamation), Colorado State University (CSU), and the Electric Power Research Institute (EPRI) have an ongoing cooperative research effort to determine...
Progressive Failure of an Overtopped Embankment
The failure of an overtopped embankment is a problem of a very complicated nature. Concerned organizations are interested in information that can be used in future planning and development...
Oxygenation Experiments in the Wave Breaking Zone
Experiments on oxygenation due to waves breaking on a uniformly sloping beach were carried out at the laboratory of Harbor Works, National Technical University of Athens. The influence...
A Finite-Difference Model for 3-D Flow in Bays and Estuaries
This paper describes a semi-implicit finite-difference model for the numerical solution of three-dimensional flow in bays and estuaries. The model treats the gravity wave and vertical...
The Courant Number and Unsteady Flow Computation
The Courant number C, the key to unsteady flow computation, is a ratio of physical wave velocity, ?, to computational signal-transmission velocity, ?, i.e., C = ?/?. In this way, it uniquely...
Three-Dimensional Modeling of Tides and Wind-Waves
A third-generation coupled discrete numerical wave prediction model is dynamically linked to a three-dimensional hydrodynamic model. The effects of water level, currents, and bottom friction...
Sliplining: Design and Installation Considerations for Polyethylene Pipe
The design methodology and installation procedure for polyethylene slipline renewal are discussed. When designing there are two critical phases which must be considered: (1) short-term...
Structural Design on Ductile Iron Pipe
The thickness class designation for Ductile Iron pipe has been changed to a pressure class designation in the 1991 revision of the C150/A21.50 ANSI standard. However, the same conservative...
Reinforced and Prestressed Concrete Pressure Pipe Diagnosis
Prestressed and reinforced concrete steel cylinder pipes are used for transmission mains, water intake lines, sewers force mains. Many collapses caused by the steel cylinder attack were...
Selection and use of Pipeline Leak Detection Methods for Liability Management into the 21st Century
Pipeline leak detection systems have been in use for many years on all types of pipelines with various products being transported. Pipeline owners and operators are subject to stringent...
Relocating a 54-Inch Diameter Force Main without Interrupting Wastewater Flow
The City of Tampa, Florida, was faced with the challenge of relocating three segments of an old 1372 mm (54-in.) diameter reinforced concrete pipe force main, totaling nearly a mile in...
The Load Factor
Spangler's load-factor formula for projecting conduits is generalized to all cases of buried rigid pipe, whether in trenches or under embankments; this is in accordance with the analytical...
RCC: Rehab Results
Thirty dams have been modified with roller compacted concrete in order to provide additional spillway capacity and for safe overtopping of embankment dams. In the national dam safety inspection...
Nondestructive Testing Role in Repair and Rehabilitation of Concrete Structures
Nondestructive testing (NDT) methods are increasingly being used to assess the condition of structural concrete. The paper discusses applications of NDT methods for forensic investigation...
Driven Then Pushed Minicone Tests in a Sand Chamber
For a general knowledge on the Standard Cone Penetrometer test and its uses the reader is referred to the work of Briaud and Miran (1991). For this study (Khalaf and Briaud, 1992) a smaller...
Piles for Marquette University Math Building
This paper presents a comparison of static pile capacity predictions using CPT cone resistance results with results of a test pile program and production pile driving. Pile capacity prediction...
Evaluation and Monitoring of Pile Performance Using Dynamic Measurements in Supporting Offshore Structures
The installation of offshore platforms into deeper waters and new environments is accompanied by an increasing uncertainty in the structure response, foundation design and performance....
Return to search