Dynamic Response Characteristics of Jack-Up Drilling Units
The effects of five parameters on the dynamic amplification of the global base shear on a deep water jack-up drilling unit were analyzed using a time domain nonlinear model. The five parameters...
Piles Under Dynamic Loads
This proceedings,
Civil Engineering in the Oceans V
This proceedings is a collection of technical papers presented at Civil Engineering in the Oceans V (CEO V) specialty conference held at College Station, Texas on November 2-5, 1992. Initiated...
Dynamic Wind Loads
This chapter is concerned with the motions of cable stayed bridges that arise as a result of wind action. The aerodynamic phenomena that must be considered are vortex shedding, torsional...
A Conceptual Model for Vertical Frazil Distribution in Turbulent Flows
A conceptual model is presented for the evolution of frazil over depth in a turbulent flow. The net upward migration due to buoyancy of the frazil is opposed by intermittent mixing induced...
New Support for Pin-Hanger Bridges
To promote safety of their bridges, many state highway departments are considering ways to add auxiliary support to existing pin-hanger bridges. The Pennsylvania DOT and its open-end consultant...
Introduction to Structural and Mechanical Failure Modes for Nuclear Power Facilities
The three papers presented in this section discuss the types of information (i.e., dynamic tests, earthquake experience and analytical data) which are used in predicting the capacity of...
Lubrication Theory Analysis of the Permeability of Rough-Walled Fractures
Lubrication theory is used to study the permeability of rough-walled rock fractures. Two idealized models of a fracture, in which the roughness follows a sinusoidal or a sawtooth variation,...
Rethinking the Economic factors of Centralized Spent Fuel Storage
The economics of centralizing the storage of spent fuel at a single site, as opposed to continued storage at over 100 reactor sites, has been the subject of several recent analyses. Most...
Preliminary Feasibility Assessment of Several Spent Fuel Transfer/Storage Options Suitable for Early Deployment at an MRS
This paper provides (a) an overview of the range of feasible Monitored Retrievable Storage (MRS) facility transfer and storage configurations that are available to the U.S. Department...
Industry Experience and Programs that Benefit the Monitored Retrievable Storage (MRS) Facility Design
The design objectives and criteria for an MRS must be responsive to the needs and concerns of the public and the industry. It is shown here that to the maximum extent, existing industry...
Design and Operation of a Monitored Retrievable Storage Facility Using NUHOMS? Technology
The NUHOMS dry storage system for spent fuel is now in use at two Independent Spent Fuel Storage Installations (ISFSIs) and a third is under construction. This system can be used for economical...
Field Investigations for Seismic Effects on Mechanical and Geohydrologic Response of Underground Structures in Jointed Rock
An exploratory Seismic Rock Mechanics research program has been initiated by the U.S. Nuclear Regulatory Commission at the Center for Nuclear Waste Regulatory Analyses (CNWRA) to study...
Determination of Cost Effective Waste Management System Receipt Rates
A comprehensive logistics and cost analysis has been carried out to determine if there are potential benefits to the high-level waste management system for receipt rates other than the...
Testing of Materials and Scale Models for Impact Limiters
Aluminum Honeycomb and Polyurethane foam specimens were tested to obtain experimental data on the material's behavior under different loading conditions. This paper reports...
Transportation Capabilities of the Existing Cask Fleet
This paper describes a number of scenarios estimating the amount of spent nuclear fuel that could be transported to a Monitored Retrievable Storage (MRS) Facility by various combinations...
Some Political Logistics of Nuclear Waste
The need for a centralized, federal, interim storage facility for nuclear waste, or MRS, alledgedly has become more urgent because the date for the opening of the permanent repository...
Computer-Aided Structural Analysis
Finite Element Methods and other numerical techniques are often taught nowadays in the undergraduate Structural Analysis courses. Commercial, structural computer programs are becoming...
Accurate Response Analysis of Seismic Distributed Mass Systems
A dynamic analysis technique of distributed mass structures is presented with a combination of the dynamic load factor approach and the dynamic stiffness matrix method. The dynamic stiffness...
COMBAT.PC; a New Windows-Based Tool for Three-Dimensional Dynamic Analysis of Multi-storied Building Structures
By some accounts, analytical capability without the power of visualization is little productive; visualization is the tool that will turn computational power into practical results. COMBAT.PC...
Return to search