System and Utilization Study of Japanese Experiment Module for International Space Station
The paper briefly reviews the overall system study of Japanese Experiment Module (JEM) which consists of Pressurized Module, Exposed Facility and Small Remote Manipulator System (RMS)....
High Wiring Act
Prendergast describes a project to construct a 345 kV transmission line over 313 mi in southwestern New Mexico, in which, due to environmental considerations and limited access, extensive...
HELP is on The Way
Hill and Davies describe current progress on the development of a Heavy Vehicle Electronic License Plate (HELP) system in the United States. The HELP system concept combines automatic...
Column Separation in Pumped Pipelines
Pressure transients are common occurrences in water supply systems. Pipeline standards and design/testing techniques will normally provide sufficient protection for transmission and distribution...
Comprehensive Leak Detection Survey and Benefit/Cost Analysis
Fort Carson, Colorado was the site of a comprehensive leak detection investigation of the potable water system with the express purpose of quantifying the benefits to be derived by a military...
Valve Control to Avoid Column Separation in a Pipe
Maximum pressures in a pipeline can be reduced significantly by closing the valve in an optimal manner. Such an optimal valve closure policy may result in some situations in minimum pressures...
Anchorage Sewer Rehabilitation in Campbell Lake
This paper discusses the proposed rehabilitation/replacement of the Campbell Lake portion of the Campbell Creek C-5 Trunk Sewer (C-5 Trunk) located in Anchorage, Alaska. The original corrugated...
Optimal Design of Water Transmission Mains
Capital cost for constructing a water transmission main includes cost of the pipeline and its associated installation costs. Also included in the capital cost is the cost of a pump station....
Twin Pipeline Crossing of the Fraser River
A new creek water supply was developed for the communities of Mission and Matsqui, British Columbia, Canada, in the early eighties. Over 60 kilometres of 450 mm to 900 mm diameter ductile...
Evaluation and Selection Methodology for Determination of a Preferred Pipeline Alignment
The San Diego County Water Authority (SDCWA) had need to construct a regional 108 to 72 inch (2.7 to 1.8 meter) diameter pipeline through San Diego County to increase water supply to its...
Field Experiment on Behavior of Continuous Water Main with a Miter Bend
A field experiment was conducted to investigate behaviors of a buried continuous steel water main with a 90-degree miter bend subjected to internal pressure and ground settlement. Deformations...
Museum Showcases the Future
On May 4 in Philadelphia, the Franklin Institute's new wing, called the Futures Center, will open to the public. When the institute's neoclassic main buiding...
Keeping Lifelines Alive
There were no city water supplies to fight the fires in San Francisco after last year's earthquake. The fires were brought under control because of an historic auxiliary water...
The Transportation Operations System: A Description
A system engineering approach is being applied to organize and develop relations among the people, hardware, and software of the Transportation Operations System (TOS), which will be a...
Development of Transportation Operations Requirements: Operations Planning
Transport conditions at various utility sites vary dramatically in terms of characteristics at and near the site, requirements, administrative procedures, and other factors. Continuation...
Identification of Facility Constraints That Impact Transportation Operations
As Federal Waste Management Systems (FWMS) receiving facilities become available, the U.S. Department of Energy (DOE) intends to begin accepting spent nuclear fuel from U.S. utilities...
MRS Systems Study, Task F: Transportation Impacts of a Monitored Retrievable Storage Facility
The passage of the Nuclear Waste Policy Amendments Act of 1987 (NWPAA) modified the basis from which the Office of Civilian Radioactive Waste Management (OCRWM) had derived and developed...
Optimal Route Selection for High Level Nuclear Waste Transport Based Upon Radiological Risk
The purpose of this paper is to demonstrate route optimization based directly upon the minimization of radiological risk as computed from local conditions. An operational impact analysis...
Optimizing Spent Fuel Cask Designs for Use in the Federal Waste Management System
The DOE will design and develop a new fleet of casks to transport spent fuel using innovative approaches to optimize the cask design. Preliminary casks designs indicate capacity increases...
BR-100 Spent Fuel Shipping Cask Development
Continued public acceptance of commercial nuclear power is contingent to a large degree on the U.S. Department of Energy (DOE) establishing an integrated waste management system for spent...
Return to search