A Comparison of the Cyclic Performance of Bolted and Riveted Connections
As part of a larger project to investigate the performance of older steel frames, a comparative study of bolted and riveted T-stub connections was conducted. The study included connections...
Some Unresolved Issues in Seismic Steel Codes
In the latest revisions of the three major U.S. seismic codes (AISC, NEHRP, UBC) some requirements can be questioned because of limited knowledge. Confining attention to conventional kinds...
A Wind Tunnel Study of an Aeroelastic Model of the Florida Suncoast Dome
Very large scale cable domes have been built using prestressed, high strength steel cable or strand, steel tube columns and a lightweight fiberglass skin. Geiger Engineers Florida Suncoast...
Tuned Mass Damper in Tall Building Design
Viscoelastic dN and tuned mass dampers are often used by tall building designers to control wind-induced building vibrations resulting from such phenomena as vortex shedding, galloping,...
Vortex Shedding Induced Fatigue Fracture of Mast Tower
The fracture of a pair of 60m high circular steel masts is investigated. The design criteria and fabrication practices are reviewed. The cause of failure is related to the fatigued condition...
85 Stories in Kuala Lumpur?The 5th and 6th Tallest Buildings in the World
A concrete core and cylindrical concrete tube structure provides a safe, elegant, efficient and constructible solution to the challenge of designing the world's 5th and 6th tallest buildings,...
Steel Plate Energy Absorbers for Improved Earthquake Resistance
This paper discusses results of an combined experimental and analytical investigation on seismic response of frame structures using welded steel triangular plates as added damping and...
Response of Equipment in Structures Supported on Resilient-Friction Base Isolators Subjected to Ground Motion
In this paper, the response of equipment in structures on a particular friction-type device, the resilient-friction base isolator, is examined. The R-FBI is composed of layers of Teflon...
Seismic Base Isolation Design for the San Bernardino County Medical Center Replacement Project
The SBCMC Replacement Project, located in Colton, California, consists of six separate building structures containing a total of approximately 86,000 m2...
Behavior of Horizontally Curved Steel Highway Bridges
Horizontally curved highway bridges represent up to 25 percent of the market for new steel-bridge construction each year. However, unanswered questions remain concerning the fundamental...
Joint Design in Composite Columns/Steel Beam Structures
The use of a composite building system, utilizing a composite exterior column and a concrete spandrel beam system, proposed by Dr. Fazlur Khan in 1967, is recalled. In the last 25 years,...
Axial Capacity of Concrete Infilled Steel Box Column with Biaxial Bending
The objective of this study was to investigate the feasibility of using the Bresler reciprocal load method to calculate the axial capacity of a concrete infilled steel box column subjected...
Concrete Arch Bridges for Supporting Steel Conduits of Mingtan Pumped Storage Project
For the Mingtan Pumped Storage Project of an installed capacity of 1600 MW, two parallel waterways have been constructed for conveying flows between the upper reservoir and the lower reservoir...
Lateral Bracing of Plate Girders Using Deck Forms
The initial results of a study of the ability of stay-in-place steel deck forms to stabilize bridge girders during construction is presented. The analytical and experimental results to...
Long Life Fatigue Behavior of Welded Steel-Bridge Girder Details
The Federal Highway Administration is nearing completion of a five year, 1.5 million dollar effort titled 'Variable Amplitude Load Fatigue' to investigate the behavior of welded bridge...
Inelastic Bridge Rating Procedures for Steel-Girder Bridges
Current bridge rating procedures for steel beam and girder bridges ignore the ability of the structure to redistribute forces both longitudinally and laterally. When rating steel bridges...
Steel Alternates for the Hoover Dam Bridge
As input to the Environmental Impact Statement studies of appropriate long span bridges were performed for three alternate corridors across the Colorado River near Hoover Dam. Details...
Influence of Diaphragms on the Overall Performance of Bridges
Field data collected during vehicular loading has been used to evaluate the performance of diaphragms in composite steel plate girder bridges. This has included comparisons with finite...
Physical Testing of Two R/C Skewed Slab Bridges with Integral Wall Abutments
Two one-third scale models of an existing reinforced concrete skewed slab bridge with integral wall abutments were tested statically to failure. Typically, these bridges are designed using...
NDE of Steel Bridges by Acoustic Emission
Acoustic emission technique (AE) was used to investigate fatigue cracking phenomenon during a series of laboratory tests of various bridge steels and during field testing of an in-service...
Return to search