Terminal 5 Renovation?Port of Seattle
The Port of Seattle is currently renovating its Terminal 5 facility on the west bank of the Duwamish River on the west side of Harbor Island in Seattle. This paper describes the methods...
Channel Design Criteria and the Houston Ship Channel
Channel design literature is reviewed and compared with operational limits currently on the Houston Ship Channel (HSC). It was found that in all aspects of channel design considered (depth,...
Seismic Design of Earth Retaining Wharf Structures
Seismic design considerations pertinent to earth retaining wharf structures are reviewed. These considerations include: evaluation of the seismic environment and design earthquake ground...
Marginal Wharf and Embankments?Seismic Design
This paper presents some of the seismic considerations used for the improvements at Berths 225 to 229 at the Port of Los Angeles. The design of the improvements was complicated by the...
Construction Materials for Civil Engineering Projects
The materials of construction in use today have grown in number, increased in complexity, expanded in application and multiplied in utilization over those in use just a short time ago....
Lifeline Seismic Risk Analysis?Case Studies
These papers employ design concepts and procedures in lifeline seismic risk analysis. Two of the papers describe the seismic hazards in the northwestern United States. A systems model...
Effectiveness of Highway Safety Improvements
This book contains the thirty papers presented at the third Highway Safety Specialty Conference sponsored by the Committee on Traffic and Safety of the Highway Division of the American...
Expert Systems in Civil Engineering
The importance of expert systems, also referred to as knowledge based expert systems, has been growing in all areas of civil engineering practice. The papers in this book were presented...
Building Motion in Wind
The trend towards higher structural efficiency and hence lower cost has resulted in a generation of lighter and more flexible buildings with a lower inherent capacity for energy dissipation...
Asphalt Pavement Modifiers
Modifiers or additives to asphalt concrete pavements are being researched or marketed by many major chemical firms. Modifiers or additives are used to stiffen the asphalt in hot weather...
Superminis for Super CAD
Many second time users of computer-aided design software and hardware, in their efforts to have more power and flexibility, are switching to superminicomputers and building their own systems....
CAD Goes into Analysis
In the past, computer analysis of a design was always a separate and distinct step from CAD. Now, an increasing number of systems are combining the two. One system, SSCAD, allows the engineer...
CAD Mapping Trailblazer
Until three years ago, few civil/surveying firms had automated both surveying (including digital recording of angles and distances shot in the field) and the related design and drafting....
Use of In Situ Tests for Foundation Design on Clay
Years of evaluated experience with the field vane test in soft clays have resulted in empirical correction factors well suited for design practice. An extension of L. Bjerrum's...
Use of SPT and CPT Tests for Evaluating the Liquefaction Resistance of Sands
A cone penetration test (CPT)-liquefaction resistance relationship has been established using the large body of standard penetration test (SPT) data. Factors for relating CPT tip resistance...
Pressuremeter Tests and Shoring Wall Design
Pressuremeter testing was used as an integral part in the design of the temporary tieback shoring wall for the Columbia Center office building in Seattle, Washington. Pressuremeter testing...
Laboratory and Field Evaluation of Cone Penetrometers
Cone penetrometers from 8 organizations have been studied by performing laboratory tests and field tests. The testing show that pore pressure and temperature zero shift affect significantly...
In-Situ Testing to Characterize Electric Transmission Line Routes
A review of the literature has shown few definitive studies which separate test variability from soil inhomogeneity. A sensitivity study was performed to evaluate the effects of the overall...
Effect of Cementation on the Cone Penetration Resistance of Sand
A laboratory study was conducted to investigate the effect of cementation on the cone penetration resistance of sand. A new apparatus to form homogeneous artificially cemented sand specimens...
Design Parameters for Grouted Piles in Rock From In-Situ Load Tests
A series of pile load tests were performed at an onshore site to develop final geotechnical parameters for the Gaviota platform foundation which consists of large diameter drilled and...
Return to search