Blast Mitigation Research and Technology Transfer
Terrorists continue to use bombs as a weapon of choice. Recent bombings targeted against the United States, such as the World Trade Center, Murrah Federal Building, Khobar Towers, and...
New Concepts in Structural Strength Assessment for Large Buildings in Fire
This paper presents theoretical descriptions of the key phenomena that govern the behaviour of composite framed structures in fire. These descriptions have been developed in parallel with...
Performance of Masonry in Disasters: Lessons Learned and Research Needs Identified
This presentation described in this extended abstract is one of several in a panel discussion entitled Enhanced Research in Masonry. The objectives of the presentation are to discuss the...
Update of Serviceability Design Considerations for Low-Rise Steel Buildings
In 1990, the American Institute of Steel Construction published Servicability Design Considerations for Low-Rise Buildings by James M. Fisher and Michael A. West. This document was published...
Seismic Analysis and Retrofit of the Amoskeag Bridges
In 1983 AASHTO first offered the design guide for seismic analysis of bridges, which ultimately became a permanent part of the AASHTO Bridge Design Manual in 1990. Prior to this time,...
Rehabilitation of the Packers Falls Bridge
The Packers Falls Bridge was constructed in 1912 and consists of a 42' (12.8m) single span, reinforced concrete arch structure. This bridge was constructed using a unique forming system...
Evolution of Composite Floor Systems in the United States
Composite floor systems, which combine structural steel beams with a cast-in-place concrete slab, have grown in popularity in the U.S. during the past 40 years. In most early applications,...
Cyclic Behavior of Three-Dimensional Partially-Restrained Composite Connections
This paper describes the test of a full-scale, bi-directional, PR composite beam-to-column connection. The PR connection consisted of continuous reinforcement bars across the column and...
Structural Lumber from Small-Diameter Western U.S. Softwood Trees
The purpose of this study was to determine the mechanical properties, and corresponding economic value, of dimension lumber produced from selected over-stocked forest stands of small-diameter...
Small-Diameter Round Timber Connections
An over stocking of trees having diameters less than 20 cm, as measured 1.52 m off the ground presents a major fire hazard to over 54 million acres of National Forest land. Improving the...
Piece by Piece
The Lions' Gate Suspension Bridge, a landmark structure in Vancouver, British Columbia, marks the entrance to one of the busiest harbors on the west coast of North America....
Returning to the Source
One hundred years ago, Las Vegas was a dry, dusty dot on the map with a population of only 100. The city grew up to become perhaps the gambling capital of the world, and more recently...
Small Firms, Big Dig
The local knowledge and technical expertise found in small engineering firms are often critical to the success of large projects. As one of the most comprehensive design and construction...
Life at the End of the Tunnel
Deadly tunnel fires in Europe have raised new concerns about tunnel fire safety around the world. Modifications to structures, mechanical systems, and operating procedures can make new...
Mile High Design
Denver's hybrid steel and concrete Invesco Field at Mile High, the National Football League's first design/build stadium, is on schedule to replace the existing...
High-Tech Isolation
In the fast-paced world of telecommunications, the time to market is often the deciding factor in the success of an enterprise. With that thought in mind, AboveNet Communications, Inc.,...
Pushing Back
(Available on in special edition) The design for the $3.5-million Cameron Run tunnel rehabilitation project involved a tricky and relatively unproven method of pushing corrugated steel...
The Pentagon Project
The renovation of the Pentagon, now under way, is one of the most ambitious, complex, and challenging construction undertakings in contemporary history. It entails the equivalent of demolishing...
Under the Microscope
Forensic engineering is typically more complex than engineering design because it requires the integration of specialized knowledge of materials science, structural analysis and design,...
A GIS Model for Assessing the Impact of Increased Channel Discharges on Hydraulic Geometry
A GIS model is being developed that can be used to assess the impact of increased channel discharges on the hydraulic geometry of streams in the Powder River (structural) Basin in northeast...
Return to search