Oil Hydraulic Design for Turbine Control
The paper addresses three areas of Oil Hydraulic Design for Francis and Kaplan Turbines: smart accumulator condition sensors, high flow servo logic, and high pressures Wicket Gate cylinder...
Hydro Turbine Submergence
The elevation of a hydro-electric turbine above or below tailwater is based on hydraulic model studies to determine the critical sigma, defined as the ratio of barometric pressure plus...
Turbine Efficiency Measurements by the Pressure-Time and the Current-Meter Method at Paugan
Paugan generating station was built in the 1920s. Although the generators were converted from 25 Hz to 60 Hz in the mid 1950s, the original runners were in place until recently when a...
Transient Analysis of the Finchaa Hydroelectric Project
An iterative computer simulation procedure called LIQT (Liquid Transient), which performs simulations of hydraulic transients in closed conduit hydro-power systems, is used to estimate...
Fluctuating Pressure Measurements on a Large Hydro Turbine
The New York Power Authority is investigating the feasibility of upgrading the thirteen 150,000 kW turbines-generators at the Robert Moses Niagara Power Station to improve efficiency and...
Beam-Supported Slabs Subject to Edge Loading
A model is presented which allows a designer to estimate stiffnesses required to provide a given critical buckling load in beam-supported slabs subjected to biaxial edge loading, such...
High Pressure Grouting of the Bath County Tunnel System
A major grouting program was completed at the Bath County Pumped Storage Project between March and September 1985. High pressure grouting for seepage reduction was completed in a total...
Fretting Corrosion on Large Split Thrust Bearing Runners
In the early fifties interfacial slip was measured on laboratory models. Design improvements, resulting from these tests, were incorporated into later machines. These improvements appreciably...
Our Municipal Water System Has Power
Hydroelectric potential exists in the Boulder, Colorado municipal water system. Excess pressure is developed in the water system because the water originates in the Rocky Mountains, west...
Frequency Domain Site Response with Pore Pressure
A frequency domain analysis for seismic site response and liquefaction potential is developed. The analysis is based upon a nonstationary random vibration theory. The model uses an effective...
A Stochastic Model for Low-Cycle Elastic-Plastic Fatigue Crack Growth
In this paper a stochastic process approach is considered to represent the random nature of the low-cycle (elastic-plastic) fatigue crack growth process. A semi-Markov renewal model is...
Pore Pressure Development: Probability Analysis
The development and subsequent dissipation of excess pore pressure, p in a soil deposit subject to an external load is examined using probability concepts that account for uncertainties...
Time Series Analysis of Wind Pressures on Low Buildings
A new methodology for the description of local wind pressures on the building envelope of mono-sloped roof buildings by using time series analysis is described. A simple AR(1) model has...
Pressures on Prisms in Turbulent Shear Flows
Experimental results are presented which show that Melbourne's 'Small Scale Spectral Density Parameter,' S, controls the negative pressures on the...
Water Distribution Network Calibration Considering Multiple Loading Conditions
Through time a water distribution network's carrying capacity is reduced as material collects on pipe walls. The impact varies with each pipe in the system and occurs at an...
Experimental and Historical Verification of the Performance of Naturlly Armouring Breakwaters
A series of hydraulic model test were carried out to investigate the mechanism by which naturally armoring breakwaters, that is breakwaters in which the initial profile is adjusted into...
Dilatometers Settle In
The benefits of the dilatometer test DMT are described. This geotechnical in situ testing tool was developed and patented by an Italian professor and engineer named Silvano Marchetti....
New Installation Designs for Buried Concrete Pipe
The rational development of new installation designs for buried concrete pipe is described. Over 100 analyses were performed using a new computer program named SPIDA (Soil Pipe Interaction...
A Multilayered Model for Analysis of Composite Pipes
A multilayered model is developed to analyze the behavior of composite pipes, such as prestressed concrete pipe, to the combined effects of internal pressure and applied loads. The pipe...
Control of Surge Pressures in Irrigation Systems
Excessively high or low pressure within an irrigation system can result in damage to pipelines, pumps, valves, and on-farm facilities. Frequently, these pressure variations are caused...
Return to search