Review of API Guidelines for Pipe Piles in Sand
Most offshore structures are supported using steel pipe piles which are designed in accord with API Recommended Practice 2A. The guidelines for analysis of axial capacity of steel pipe...
Homopolar Pulse Butt Welding of API 5L Line Pipe
Homopolar pulse welding (HPW) is a welding process that is being investigated as a means to rapidly join API line pipe, having particularly great potential for application in deepwater...
A Fourier Series Solution to Bottom Roughness Induced Stresses During Pipe Laying
Often during installation, a subsea pipeline must be laid along seabed portions with rough profiles. The pipeline is forced by the bottom irregularities to bridge across consecutive protuberances....
Manholes and Microtunneling
Contractors are for the Oakwood Beach Interceptor Sewer Project, on Staten Island, N.Y., were having difficulty. Glacial tills and a high water table made working 90 ft below the ground...
Pressure Pipeline Design for Water and Wastewater
This committee report,
Cables and Anchorages
The following types of cables are generally used in cable stayed bridges: Parallel bars; Parallel seven wire strands; Parallel or semi-parallel wire cables; Locked coil strands and ropes;...
Decentralized Wastewater Management
With the discovery earlier this century that city squalor caused disease, we protected ourselves by piping raw wastes away. Later, when the discharge had transformed rivers into foul,...
Soil-Pipe Interaction During Frost Heaving Around a Buried Chilled Pipeline
The freezing of soil water around a buried chilled pipeline leads to soil heaving, which is affected by the presence of the pipe. This process may eventually cause pipeline failure. The...
Numerical Analysis of Frost Shields
The term 'frost sheilding' has been used to describe the practice of using flat stock rigid insulation materials burial above a water or sewer pipe to reduce...
Size Effects in the Fracture of Quasi-Brittle Materials
Causes and influences of the structural size effect that is exhibited by materials such as concrete, mortar, ice rock and ceramics, are discussed. The size effect law, which models this...
Procedure for Seismic Evaluation and Design of Small Bore Piping
Simplified methods for the seismic design for small bore piping in nuclear power plants have been used for many years. Various pipe designers have developed unique methods to treat the...
Recirculation Piping Replacement Project at Dresden Unit 3
This paper discusses the Recirculation Piping Replacement Project performed at Dresden Unit 3 during 1985 and 1986. It describes several of the technical and administrative problems associated...
Durability, Mechanical, and Thermal Properties of Experimental Glass-Ceramic Forms for Immobilizing ICPP High Level Waste
The high-level liquid waste generated at the Idaho Chemical Processing Plant (ICPP) is routinely solidified into granular calcined high-level waste (HLW) and stored onsite. A research...
Boundary Integral Methods for Unsaturated Flow
A boundary integral equation method (BIEM) is described for numerical analysis of quasilinear steady unsaturated flow in homogeneous material. The applicability of the exponential model...
Emplacement Drift Temperature Reduction by Cooling Enhancement and Ventilation
The application of cooling enhancement in a short vertical container emplacement layout is analyzed. Two 25 m-long heat pipes upward oriented at 45 degrees are installed at each emplacement...
Boston's Sewage Outfall
The centerpiece of the Boston Harbor cleanup plan will be the sewage plant on Deer Island, which will treat water from 43 municipalities in the Boston metro area�500 mgd to start. In order...
Infrared Thermography Based Pipeline Leak Detection
Computerized Infrared Thermographic pipeline inspection is now a refined and reliable process having been thoroughly proven to be an accurate, cost effective, and efficient technology...
Design Program for Gravity Sanitary Sewers
The Gravity Sewer Design Program Version 2.1 M (GSDP2M) performs the hydraulic design for a conventional gravity sanitary sewer network. GSDP2M is written in standard Fortran 77 for batch...
Application of GIS in Monitoring and Trouble Shooting of Water Distribution Systems
In this study, the suitability of Geographical Information System (GIS) to monitor water distribution systems is investigated. Although GIS applications are widespread, the use of GIS...
Diagnostic Options for Pipeline Rehabilitation
The various diagnostic options utilized for solving pipeline problems/failures continue to increase at a very rapid pace. Field reconnaisance and/or man-entry of pipelines is becoming...
Return to search