Comparison of Caisson Load Tests on Chicago Hardpan
The results from two relatively recent instrumented caisson load tests from different sites on Chicago Hardpan are compared with a 'classic' large scale caisson...

Observations on Load Tests for Drilled Shafts
This paper focuses on three specific areas pertaining to load tests for drilled shafts: 1) basic considerations and load testing procedures, 2) interpretation of uplift load test information,...

Review of Repeated Axial Load Tests on Deep Foundations
A review of the literature is presented on the axial capacity of deep foundations subjected to repeated loads. Data are summarized on anchors, driven piles, and drilled shafts. In general,...

Quality Assurance/Quality Control; Case Studies?Introduction
The report emphasizes several requirements for quality management: a. The need for a knowledgeable field representative, preferably the resident engineer. This person must be familiar...

The Role of the Quality Assurance Management on a Large Commercial Project
The role of the quality assurance manager on a high rise project being built on a tight time schedule is a challenging and diversified assignment. It is made especially difficult when...

South Branch Rockaway Storm Water Management Study
The Division of Water Resources of the New Jersey Department of Environmental Protection, the Hunterdon Soil Conservation District, the United States Department of Agriculture's...

Modeling Streamflow Response from Minnesota Peatlands
A deterministic, continuous simulation model was developed to predict the effects of peatland development on streamflow. The Peatland Hydrologic Impact Model is largely physically based...

Landslide Hazard Rating for the Oregon Coast Range
The landslide hazard rating system for shallow soils on steep terrain over hard sandstone has three components: ground water response to precipitation, soil shear strength (including root...

Embankment Foundation Densification by Compaction Grouting
Compaction grouting is an attractive alternate for in-place densification of liquefiable soils below existing structures. Compaction grouting application concepts and procedures are presented...

Acoustic Emission Monitoring of Grout Movement
This paper describes the acoustic emission (AE) method in general, and in particular the AE system which holds significant promise in this regard. Used was a multichannel AE system which...

Grout Slurries?Thick or Thin?
In this paper some recent experiences in dam grouting in several countries are discussed where bentonite or Intraplast additives were used to control sedimentation, viscosity, grout density,...

Nonlinear Fracture Process Zone in Rock
A study of the fracture process zone was conducted to gain an understanding of the physics of crack propagation in rock. The nondestructive testing technique of acoustic emissions was...

Oil Shale Fracture Characterization by a New Model
Fracture toughness of oil shale is a property which is essential for fracture characterization needed for energy resource development and recovery. However, a data base for fracture toughness...

Load-Carrying Capacity and Remaining Life of First-Built Composite Girder Bridge in Japan
Kanzaki Bridge, Osaka, Japan, was the first steel-concrete composite bridge built in 1953 to carry the Osaka Prefectural Road over Kanzaki River. The bridge was removed in 1978 after 25...

Design and Testing of a 400 Ft Span Plate Girder Bridge
The paper describes design features and testing of the Madawaska River Bridge. The bridge is unique in being the longest span plate girder bridge in Ontario, having continuous spans of...

Composite Steel Deck Bridge: An Experimental Study
Composite steel decks with steel fiber reinforced concrete (SFRC) were developed, aiming to improve the durability of the deck pavement and to increase the rigidity of the deck plate in...

Dynamic-Fatigue Response of Continuous Composite Bridges
The dynamic response of continuous composite bridges and the influence of fatigue loading at resonance frequency on the structural response are investigated. It is shown that cracking...

Application of Preflexed Composite Beams to Continuous Bridges
A preflexed beam is a type of concrete encased steel beam of which prestressing has been introduced in the lower flange concrete. Recently, the preflexed composite beams were applied to...

The Eurocodes and Shrinkage in Composite Beams
The two parts of this paper relate to different aspects of design procedures for composite structures of steel and concrete. First, recent developments in the coordination of the eight...

Beam-to-Column Connection of a Composite Structure
Composite structures can exhibit excellent performance against seismic force, and fire safety as well. However, the traditional steel reinforced concrete (SRC) system or concrete encased...

 

 

 

 

Return to search