Strain Gaging and Data Acquisition at the TLMRF
Strain gages are the major source of data for the TLMRF (Transmission Line Mechanical Research Facility) research program. Measurement of member loads and bending moments in lattice towers...
Strength Data Base for LRFD of Transmission Lines
Reliability-Based Load and Resistance Factor Design (LRFD) has been proposed as a desirable alternative or a complement to the National Electrical Safety Code (NESC) for the structural...
Special Pile Foundations for a Coastal Permafrost Site
The design of the plant's foundations had to address several challenging geotechnical conditions. These included (1) 'warm' (close to 32 degree F)...
Adfreeze Strength of Ice to Steel Pipe Piles as a Function of Temperature
A study was initiated to determine the adfreeze bond strength between steel pipe piles and freshwater ice as a function of temperature. Tests were conducted at an average strain rate of...
Design of Tension Member Insulated Anchor for Arctic Pipelines
This paper explores the latest development in above-ground waterflood pipe anchors currently being used on the SOHIO operated portion of the Prudhoe Bay Oil Field. The objective of the...
Costs of Truck Related Highway Damage to Alaska
The cost of pavement damage to the State of Alaska for truck traffic continues to be a very controversial topic. There is no simple answer since this cost is dependent upon pavement strength,...
Survey of Airport Pavement Distress in Cold Regions
The most common pavement problems were associated with non-traffic related phenomena and included pre-existing cracks reflecting through asphalt concrete overlay (in two years or less),...
Hot Sand for Improved Traction on Icy Roads
Experiments were performed to determine if heating sand prior to spreading it on icy roads would improve the skid resistance of the road more than cold sanding. Tests were made on a full-scale...
Artificial Ice Islands for Deep Water and Production Structures
The need for an island to survive the summer melt season is introduced. To account for surface melting and erosion from waves and currents during this season, the island's...
Drilling Unit Approval and Sea Ice, Alaska OCS
This paper describes types of ice conditions that have been, or could be, encountered while conducting Alaska Outer Continental Shelf (OCS) operations. The types of ice monitoring programs,...
Iceberg Impact Load on a Gravity Based Structure
The mechanics of the eccentric collision of an iceberg against a fixed, rigid, gravity based structure are discussed. A closed form solution is derived for the case of infinite friction...
Building Foundation on Thawed Soil and Permafrost
The site of a planned 10,000 square foot State Youth Facility in Bethel, Alaska was found to be underlain by discontinuous permafrost. This paper describes the geophysical and geotechnical...
35-Year-Old Foundations, Thule Air Base, Greenland
In February 1951 the secret project 'Blue Jay' to construct the base began. Timber piling were used in the foundations of boilers, generators, and other heavy...
Stabilization of a Permafrost Subsidence in the Airport Runway at Bethel Alaska
During the construction of the extension to the Bethel Airport runway in 1969, it was necessary to construct a fill across a small gully. The subbase material in the gully contained some...
A Laboratory Study of Factors Affecting Wetted Snow Roads
A brief review of the the literature concerning the application of water to the surface of snow roads is presented. It is demonstrated that there is no general agreement on the proper...
The CBR Test Applied to Processed and Compacted Snow
The processes used during the past two decades to improve the snow bear a modest resemblance to conventional flexible pavement construction, thus the field CBR (California Bearing Ratio)...
Soil Strength Recovery Using a Clegg Impact Device
The research described in this paper uses the Clegg Impact Device to determine the relative strength of a soil, and describes how this information can be used to develop the strength recovery...
Design and Monitoring of an Ice Drill Pad
An ice pad was sucessfully designed and built to provide a suitable foundation for an exploratory drill rig in the National Petroleum Reserve of Alaska in early 1985. Design considerations...
A Self-Refrigerated Gravel Pad Foundation for Large Thermal Loads
Design criteria for a proposed power plant at Thule Air Force Base, Greenland, involved both large thermal loads from the diesel engines and large static loads from an eight foot thick...
Development of a Self-Heating Thermal Probe for Saline Permafrost
Geothermal modelling and prototype testing are described to support the development of a self-heating thermal probe. This has application for in-situ determination of the amount of unfrozen...
Return to search