Morris Sheppard Dam: A Rational Approach to Stability Analysis
This paper details the excessive foundation piezometric conditions found during a routine five-year inspection, and presents the results of backfigured stability analysis of a critical...
Is There a Future for Vacuum Sewers?
Vacuum sewers collect and transport sanitary sewage using pressure difference rather than gravity as the primary motive force. Compared to conventional gravity sewers, they use smaller...
Flexible Pipe Design Revisited
An overwhelming soil factor in the Iowa formula and random deformations at installation affords soil a prominent role in flexible pipe; this, together with a maximal deflection rule make...
Longitudinal Surface Profiles of Granular Debris Flows
Longitudinal surface profiles of granular material flowing down an inclined plane were studied by means of theoretical analysis and laboratory experiments. There are two driving forces...
Structural Control of Ground-Water Induced Debris Flows
A number of case studies have attributed debris flow initiation to the effect of elevated pore pressure from a bedrock ground-water source. Debris flows on slopes underlain by Precambrian...
Land Use Change and Soil Erosion Hazard in the Zambezi Basin
An experimental model for estimating soil erosion hazard in southern Africa (SLEMSA) was linked to a raster based Geographical Information System. Soil erosion hazard maps were constructed...
A Computational Analysis of Dynamic Interaction of Dam with Reservoir Water and Sediment
A two-dimensional model of porous media is employed to calculate the reduction of the onset hydrodynamic pressure with the bulk modulus of pore water in reservoir sediment. However, the...
Guard Gate Tests at Tieton Dam
The emergency gate hoist system on the guard gates at Tieton Dam, near Yakima, Washington, was tested as part of the United States Bureau of Reclamation Safety Evaluation of Existing Dams...
Pressure and Stress Distributions Due to a Submerged Impinging Jet
This investigation examines the pressure and shear stress distribution at a smooth planar boundary in the impingement region of a submerged vertical jet in water. The mean pressure and...
Comparison of Flush and Chamber Mounted Dynamic Pressure Transducer
Modeling of hydraulic structures often includes the measurement of dynamic pressure fluctuations. The accuracy of the pressure measurements depends upon the geometry of the tap. Flush...
Coronarization of the Autonomous Water pump
The conventional hydraulic pressure multiplier has been successfully used by Belgian technician Robert Houman (1986) to provide a dependable source of water supply to the NATO-base at...
Characteristics of Flow Pressure Pulsation and Similitude Law of Model
As described in this paper, the characteristics of flow pressure pulsation and similitude law of model are derived from experiments on some prototype dam and serial scales models....
Advances in Pipeline Materials
Pipelines transport water, storm run-off, process wastes, petroleum, natural gas, slurries, solids, sewage, steam and other fluids either by gravity or under pressure. Pipelines are also...
Selection of Hole Size for Fluidization Pipes
Two-dimensional fluidization experiments are performed on fine and medium coarse quartz sands at depths of 25.4 and 42 cm. Four supply pipes are used with orifice diameters of 1.587 mm...
Use of Scrap Tires to Harness Wave Energy
A 2.5 meter diameter wave powered pump, fabricated from scrap tires was tested from May 24, 1988 to October 1988 in the Atlantic Ocean at the North Carolina Army Corp of Engineers Waterways...
A Microplane Constitutive Model for Soils
A microplane model for the inelastic behavior of soils is presented. The microscopic constitutive equations are defined independentely for a set of microplanes covering all possible orientations,...
Governments' Role Relative to Public and Political Pressures
Groundwater quality is a major concern in the United States today. The body of law pertaining to the protection of groundwater quality is generally inadequate for the implementation of...
Building Moon Bases
It is widely accepted that the U.S. will begin to build a base on the moon at the turn of the century, and much of the design work has already been done. Based on papers presented at Space...
High Tech on Campus
Hannan Hall, the new laboratory building at The Catholic University of America, has a structure entirely made up of precast concrete panels and 24 in. deep double tees. The loadbearing...
Steel Girt Design
Procedures are presented for the design of light gage cold formed girts and hot rolled girts. The effects of continuity, sag rods, and wall sheeting are discussed. Design procedures are...
Return to search