Application of Model Pile Tests to Axial Pile Design
Experiments conducted with instrumented model pile segment probes at Harvey and Empire, Louisiana are summarized and the observed behavior interpreted. Correlations are developed for the...
Case Study of Offshore Pile System Reliability
This paper presents the results of research effort to evaluate the reliability of offshore pile foundation systems. It is an extension of previous work by the authors [14] dealing with...
Reliability and Resilience � Essential Ingredients of Sustainable Geotechnics
Sustainability of a system is its ability to survive and retain its functionality over time. In very simple terms, sustainability deals with the capacities (resistances) and demands (loads)...
2012 Geo-Wall Competition
Highlights from the Geo-Wall Competition at the 2012 Geo-Congress. Teams from 17 universities competed to construct a model mechanically stabilized earth (MSE) retaining wall out of craft...
Minimum Design Loads for Buildings and Other Structures
Static Cone to Compute Static Settlement over Sand
(Originally published in
Conical Test Load Measuring Compressibility
(Originally published in
Watershed-Based Permitting ? A Myth or Reality?
The United States Environmental Protection Agency has promulgated the Total Maximum Daily Load process to achieve the goals of the Clean Water Act. The TMDL processis applied to water...
Asphalt Parking Lot Runoff Nutrient Characterization for Eight Sites in North Carolina, USA
The objectives of this study were to characterize asphalt parking lot runoff quality and determine factors influencing nutrient concentrations and loads. Event mean concentrations (EMCs)...
Non-Destructive Strength Evaluation of a Continuous, Reinforced Concrete Slab Bridge
In the state of New Mexico, a significant number of reinforced concrete slab (RCS) bridges provide service on interstate highways I-10, I-25, and I-40 that are subjected to large amounts...
Toward a Unified Approach to Anchorage in Reinforced Concrete Design
The introduction of rationalized design procedures for cast-in and post-installed anchors inEurope and the U.S. was intended to provide a uniform factor of safety for anchorages inconcrete,...
An Experimental Study on the Behaviour of Full-Scale Composite Steel Frames under Furnace Loading
In view of recent large fires in tall buildings, such as One Meridian Square (USA), East Tower Central Park (Venezuela), World Trade Center (USA) and Windsor Tower (Spain), there has been...
Some Case Histories of Pile Foundations in Permafrost
Foundations for permafrost conditions should conform to one of three basic design principles: keep it frozen, let it thaw, or thaw the ground before construction. To keep the permafrost...
Characterizing the Pathways and Characteristics of Nutrients Discharging from Ground-Water to Surface Water
Any investigation of surface-water quality for a lake or pond requires accurate estimates of the contributing contaminant or nutrient loads. In many cases, inflow from the adjacent ground...
Strong Diagonals
Exterior Diagonal Systems that carry both gravity and lateral loads in building structures � known as exodiagonals or diagrids � are increasingly being used worldwide to provide freedom...
Offshore Technology in Civil Engineering
Hall of Fame Papers from the Early Years
Prepared by the Subcommittee on Offshore Technology Conference Support of the Coasts, Oceans, Ports, and Rivers Institute of ASCE. This series presents...
Foundation Loading: Introduction
This chapter introduces the subject of foundation loading....
Foundation Loading
This chapter discusses the tabulation of foundation loading data in Microsoft Excel....
Load Resistance Factor Design
This chapter discusses the tabulation of load resistance factor design data in Microsoft Excel....
Two-Way Slab Loading
This chapter includes drawings pertaining to two-way slab loading....
Return to search