Case Study: Steele Creek Dam Safety Analysis, Bristol, Tennessee
Steele Creek Dam creates a small recreational park lake before discharging into Beaver Creek a few hundred yards below the dam. Existing homes and trailers downstream from this junction...
Risk Analysis Applications for Dam Safety
Dam safety modifications are intended either to reduce the likelihood of the adverse consequences of dam failure or the magnitude of adverse consequences. For instance, widening a spillway...
Seismic Analysis of the Bonneville 1st Powerhouse
The Bonneville 1st powerhouse monoliths were constructed during the period of 1938 to 1942 and were designed against seismic loads using the old lateral coefficient method. The Corps of...
Cone Penetration Testing: Cost Effective Soil Exploration
On reviewing the 1987 Part 12 Dam Safety Inspection Reports for the Wisconsin River Power Company's Petenwell and Castle Rock Dams, the Federal Energy Regulatory Commission...
Effects of Uplift on a Gravity Arch Dam
This paper evaluates the behavior of a gravity arch dam when subjected to normal static loads and internal hydrostatic pressure (uplift). The ability to model uplift has become necessary...
Brule Hydroelectric Project Inflow Design Flood Study
In 1987, Wisconsin Electric Power Company (WE) was directed by FERC to provide additional spillway capacity at it's 63-foot (19 m) high Brule Dam. Original spillway capacity...
Analysis and Stabilization of Ambursen Dams?Two Case Studies
Case studies are presented about the analysis and rehabilitation of two slab-and-buttress (Ambursen) dams. The paper discusses the investigation techniques used, including sampling of...
Three Dimensional Modeling of Concrete Dams with Cracks Using Boundary Element Methods
Determining uplift pressure distributions in cracks in a concrete dam requires coupling between crack hydraulics and the stresses and displacements occurring in the rock and the concrete...
Dardanelle Turbines
The Dardanelle turbines located at river mile 205.5 of the McClellan-Kerr Arkansas River Navigation System, are experiencing an unusual amount of wear in the blade trunnion bushings. Oil...
Diagnostic Testing and Repair of Grand Rapids Generating Station's Unit Four
This paper is a case history that discusses diagnosis and correction of a variable pitch propeller type (Kaplan) hydraulic turbine problem. The turbine problem involved fatigue failures...
Application of Personal Computers to Field Flow Measurement
Flow measurements are often necessary to verify the performance of hydro turbines for regulatory, contractual, or engineering purposes. Historically, several methods utilizing various...
History of Lysimeter Design and Use for Evapotranspiration Measurements
Lysimeters are devices for measuring percolation of water through soils and sampling soil water for chemical analyses. Lysimeters have been used for over 300 years to determine water use...
Lysimeter Techniques and Application in India
Water is the most important resource and limiting factor for crop and industrial production in India, and agriculture is the largest consumer of water. The measurement of evapotranspiration...
Comparation of Different Forms of Penman Equation
The research was carried out near Foggia (in Southern Italy) at 90 m above sea level and at 41? 27' N latitude, using two drainage lysimeters, filled with a silt clay soil...
Lysimeters: Data Acquisition and Analysis
Lysimeters provide the most direct method for measuring evapotranspiration (ET). For ten years we have used weighing lysimeters capable of a resolution equivalent to 0.02 mm of water....
Modeling Tertiary Unit Performance in Large Irrigation Systems
Large irrigation systems constructed in the Asian region, deliver water over a wide area with varied agroclimatic conditions and cropping patterns. In order to evaluate the performance...
An Analytical Technique of Flow Rate Into Perforated Draintubes
The flow rate into a draintube in a saturated soil media depends on numerous characteristics such as the hole size, the number and spacing of holes, the drain size and depth. Based on...
Numerical Methods Used to Model Unsteady Canal Flow
Investigating the response characteristics of irrigation waer supply and distribution systems is essential if a good design is to be developed. Numerical simulation techniques have been...
Erosion Potential of Pacific Basin Precipitation
Average annual erosivity (EI) values were developed using 20 years of hourly precipitation data from weather stations located on each of 10 Pacific Basin islands. Average annual erosivity...
Numerical Methods for Simulating Debris Blockage Failures and Mudflows
This paper presents the procedures and results from an investigation to evaluate the hydraulic characteristics of mudflow events resulting from hypothetical failures of a debris blockage...
Return to search