Anelastic Straining in Polycrystalline Ice
This paper presents experimental observations on the influence of stress, grain size and total strain level on the magnitude of anelastic strain in granular freshwater ice. Cyclic loading...
Fractal Crushing
This paper develops an approach to a two-dimensional fragmentation process, in which floating ice floes are driven against each other and break up into smaller floes. It first considers...
Effect of Grain Size Variation on Damage in Polycrystalline Ice
This paper studies the effect of grain size distributions on damage accumulation in polycrystalline ice under uniaxial compression. The numerical results are derived from the internal-variable...
Fracture Resistance to Cracking in Ice: Initiation and Growth
The issue of notch sensitivity and brittleness of the test failure is used to forecast the necessary specimen size for a material property initiation toughness; a methodology is developed...
Laboratory Observations of Macroscopic Failure Modes in Freshwater Ice
A review is presented of tests performed in the laboratory by several investigators on indentation in freshwater ice. A number of the observed failure modes are discussed. From the results,...
Modeling of Floating Ice Sheets
Rectangular finite elements are studied and their suitability to investigate behavior of floating ice sheets is discussed. A simple model of the plate on one parameter, Wrinkler type,...
Loads and Vibration Induced by Compressive Failure of Ice
In earlier work, attention was focussed on the narrow length of crushed ice adjacent to the structure, which was seen as the seat of vibration associated with ice crushing. Crushed ice...
Application of Ice/Structure Interaction Concepts to a Real Time Ice Risk Assessment Computer Model
The successful and safe operation of an Arctic offshore exploration structure greatly depends on the implementation of alerts procedures. In order to assess alerts levels, a computer model...
Wang's Equation for Ice Forces From a Pressure Ridge
Yung-shih (Tony) Wang has presented an equation for the breaking loads from a multiyear pressure ridge on a conical structure. The three distances that define the position of the plastic...
Snow Transport as a Function of Wind Speed and Height
When limitations are placed on mass flux in the saltation layer, a regression equation relating mass flux to wind speed and height above surface, developed by Mellor and Fellers (1986),...
Spray and Ice Measurement Instrumentation for Ships
Bow slamming is the primary water delivery mechanism for ship superstructure icing. Spray flux is largely dependent upon hull dynamics, and cannot be computed numerically with current...
Recommended Cold Regions Meteorological Instrumentation
For nearly 30 years, CRREL has studied environmental conditions in winter weather. These efforts have concentrated on providing field-measured meteorological data and historical climatological...
Structural Renovation of Tall Chimneys
This paper describes several tall chimney projects where major renovations were performed to the linings which required complete structural analysis of the existing chimney and foundation....
Modeling in Support of Hanford Site Waste Management
The waste management practices for both radioactive and hazardous wastes at the Hanford Site are designed to comply with all applicable state and federal regulations. Results from numerical...
Procedure for Seismic Evaluation and Design of Small Bore Piping
Simplified methods for the seismic design for small bore piping in nuclear power plants have been used for many years. Various pipe designers have developed unique methods to treat the...
Optimization Models for Acid Rain Control
A series of related optimization formulations are presented for developing and analyzing acid rain control strategies. These models span a wide array of approaches and reflect a similarly...
Introduction to Structural and Mechanical Failure Modes for Nuclear Power Facilities
The three papers presented in this section discuss the types of information (i.e., dynamic tests, earthquake experience and analytical data) which are used in predicting the capacity of...
Containment Capacity and Failure Modes Beyond Design Basis Conditions
Analytical and experimental studies have shown that containments can at least sustain two to three times design pressures. Under the severe accident overpressure loading, experimental...
The Pittsburgh MAGLEV Project
A passenger transportation crisis exists in the United States which experts predict will only worsen, wasting billions of U.S. dollars. Magnetic Levitation (MAGLEV) is a promising new...
Low-Rise Shear Wall Failure Modes
A summary of the data that are available concerning the structural response of low-rise shear walls is presented. These data will be used to address two failure modes associated with shear...
Return to search