Revised Hydraulic Design of the Rio Hondo Flood Control Channel
The US Army Engineer District, Los Angeles has completed a major review study of the Los Angeles County Drainage Area (US Army, 1992) and has determined that the existing flood control...

Use of a Modified Hybrid Model to Analyze the Effectiveness of Jetties in Reducing Marina Sedimentation
The effectiveness of the construction of jetties near the entrance channel of a coastal marina in reducing marina sedimentation has been analyzed using a modified hybrid model. The modified...

Chezy Formula Versus Theory and Common Sense
Using the theoretical concepts of the uniform flow formula and the inverse solution of the Chezy equation it is shown that a channel shape may have considerable influence on the value...

Size Characteristics of Debris Flow Deposition
The size distribution of debris flow deposition is extremely wide which may contain nearly all particles from clay and colloid to boulder. Particle size and composition have very important...

An Approach to the Calculation Method of Mean Sediment Size
Mean sediment size is an important parameter expressing the characteristics of sediment. Several calculation methods of mean sediment size which are popular at present almost have some...

PSF-PM Verification of 3D Free Surface Flow Models
This paper reports an application of the Prescribed Solution Forcing (PSF) and Physical Modeling (PM) to the development of a systematic procedure for the verification of three-dimensional...

3D Free Surface Flow Model Verification - A Panel Discussion on Test Cases
This paper is to briefly present the objectives and approaches of the Panel Discussion on test cases to be developed for 3d free surface flow model verifications, so that professionals...

Analysis of Sand Movement on Noto Coast by Geochemical Method
The analysis of sand samples by X - ray fluorescent spectroscopy (abbreviated by XRF) gives the ratio of the geochemical elements to construct the sand samples. This shows the geochemical...

Sediment Transport in Sewers and Design Implications
Extended studies on sediment transport in sewers were conducted at the University of Newcastle upon Tyne and using this new as well as previously available data an attempt has been made...

Modeling Kinetics of Sediment Removal in Water Columns
Many physical, chemical, and environmental factors govern the rate of cohesive particle sedimentation in aquatic environments. A new information-based model that uses experimental information...

High Level Radioactive Waste Management 1994
The proceedings of the fifth International Conference on High Level Radioactive Waste Management, held on May 22-26, 1994, Las Vegas, Nevada, continues a concerted effort to transfer technology...

Predicted and Measured Behavior of Five Spread Footings on Sand
This publication contains the results of a full scale load testing program used to predict and measure the bahavior of five spread footings on sand. These results were presented at the...

Risk-Based Decision Making in Water Resources VI
This proceedings, Risk-Based Decision Making in Water Resources VI, contains edited papers presented at the sixth Engineering Foundation Conference...

Cement Manufacture and Use
This book, Cement Manufacture and Use, consists of papers presented at an Engineering Foundation meeting held in Potosi, Missouri. These papers...

Ground Failures Under Seismic Conditions
This proceedings, Ground Failures Under Seismic Conditions, contains invited and contributed papers which focus on the behavior of silty and...

The Influence of Water Glass on the Technological Parameters of Shotcrete
Shotcrete used in tunneling must follow a clearly defined early strength development in order to comply with stresses from rock deformations and drilling and blasting. Accelerators are...

New Advances in Shotcrete Additives: The DELVO System
The DELVO system is a two component, nonchloride chemical system developed to control the dynamics of cement hydration. Concrete, treated with the DELVO system, can be kept in a plastic...

Advances in Dry Shotcrete Technology by Means of Microsilica
During the last decade microsilica has been increasingly used to improve both wet and dry mix shotcrete. In the traditional dry process microsilica is blended in the dry mixture. Since...

An Identity Chart for Steel Fibers
Improvements in ductility and toughness by adding steel fibers to the shotcrete mix are sufficient to enable steel fibers to be used as replacement for steel mesh reinforcements. Steel...

Use of Steel-Fiber Reinforced Wet-Mix Shotcrete in Extreme Rock-Bursting Conditions
If the stresses close to tunnels or caverns exceed the capacity of the surrounding rock, rock-bursting might start. When tunneling in such rock conditions the need for a safe, quick and...

 

 

 

 

Return to search