A Storm Water Utility Case Study, Salt Lake City, Utah
In response to financial pressure on the City's general fund and the EPA's storm water regulations, Salt Lake City went through the process of developing and implementing a storm water...
The Desalination Situation
Rapid growth is putting increasing pressure on water supplies in coastal communities. Conservation can only do so much, and providing new freshwater supplies is getting more expensive...
Broadside Current Forces on Moored Ships
A method of estimating the static lateral current force on ships in deep and finite depth water is presented for the case of the current broadside to the ship. The method is based on recent...
Corrosion Fatigue of Deepwater Offshore Materials
Evaluation of the fatigue life of offshore structures operating in depths of up to 10,000 feet (3,048 m) requires knowledge of the combined effect of axial and hydrostatic loading on the...
A Fourier Series Solution to Bottom Roughness Induced Stresses During Pipe Laying
Often during installation, a subsea pipeline must be laid along seabed portions with rough profiles. The pipeline is forced by the bottom irregularities to bridge across consecutive protuberances....
Pressure Pipeline Design for Water and Wastewater
This committee report,
A Laboratory Study of Shock Waves in Frozen Soil
This work has focused on two aspects of dynamic behavior of frozen soil: first, on the shock pressure attenuation, and second, on the shock Hugoniot. The use of long bars of frozen soil...
Effective Pressures Measured During Indentation Tests in Freshwater Ice
Indentation tests were conducted by pushing flat, vertical indentors of two different widths (50 and 100 mm) against the edges of floating, freshwater ice at different velocities (0.6-150...
Approximate Preliminary Methods for Design of Lateral Load Resisting Systems in High Rise Buildings
A new group of optimization programs uses the speed and power of modern computers to eliminate the need for guessing preliminary sizes. Starting with any arbitrary sizes and a fixed geometry,...
Variation of Permeability with Temperature in Fractured Topopah Spring Tuff Samples
Fractures will play an important role in the near-field hydrology of a nuclear-waste package in a mined repository. Our previous studies showed that the water permeability of fractured...
An Alternative Method to Mariotte Reservoir System for Maintaining Constant Hydraulic Pressure
Several problems with the Mariotte reservoir system were discovered when it was used to apply a constant water pressure as a boundary condition for a prolonged period. The constant-pressure...
Rebuilding Buried Pipelines Without Digging
Advances and refinements in trenchless reconstruction technologies now permit system rebuilding of gravity and low pressure pipelines without excavation. Through the use of cured-in-place...
Optimizing Urban Ground Water Supply Systems
The cost of Pumping comprises a major part of total water operation and maintenance expenses. Most utilities attempt to keep these costs down. However, there are areas of study that may...
Minimum Required Lateral Stiffness of Structures
In this paper an approximate method is presented to calculate the minimum lateral stiffness required to insure global structural stability. The technique is based on setting the critical...
Hydrodynamic Pressure on an Oscillating Vertical Plate
The hydrodynamic pressure on an oscillating vertical plate could be influenced by the effects of compressibility of fluids and surface waves. The compressibility is effective for higher...
Computation of Wind Flow Around a Building
A numerical investigation of wind flow around a three-dimensional building is presented by solving weakly compressible flow equations, together with Smogrinsky's subgrid-scale...
Non-Linear Passive Elastic Properties of the Left Ventricular Myocardium: Application of Finite Element Analysis to 3-D Geometry Obtained from Ultrasound Images
A finite element (FE) analysis and an optimization algorithm were employed to assess the nonlinear passive elastic properties of left ventricular myocardium in a canine mode. The three-dimensional...
In-Vitro Measurement of Static Contact Pressure Distribution in Synovial Joints
The objective of this presentation is, at first, to review the various approaches to the measurement of contact pressure distribution in synovial joints, and then to describe the development...
R/C Columns Under Axial and Bi-Directional Lateral Loads
The reliability of a model, called a multi-spring model, was examined to simulate the observed response of reinforced concrete columns subjected to varying high axial loads and bi-directional...
Material Testing at High Pressure
A static test cell has been designed and fabricated to apply a peak stress of up to 2 GPa to a 2.54 cm cylindrical specimen. The cell design was based on the 'belt'...
Return to search