Composite Materials for Structures on Planetary Surfaces
Development of structures for planetary surface environments depends upon the use of the most appropriate materials. Advanced composite materials are apparently the best candidates for...

Comparison of Micromechanical Models for Elastic Properties
The effective elastic properties for unidirectional composites, as predicted by several analytical micromechanical models are compared for glass/epoxy and graphite/epoxy. A brief review...

Optimum Design of Laminated Composites
The increased demand for high strength, light weight materials that function successfully in high temperature environments has caused the effective development of laminated composites...

Simple and Efficient Methods to Produce Construction Materials for Lunar and Mars Bases
A microwave heating method and a cold press method are proposed as simple ways to produce construction materials on the Moon and Mars. The present experiment on the microwave heating method...

Steam Injection System for Lunar Concrete
Since January 1989, the Department of Civil Engineering at the United States Air Force Academy has been conducting research on the use of concrete for constructing permanent facilities...

Concrete Construction on the Moon
Building bases on the Moon, according to Space Exploration Initiative, may start in the early 21st century. Concrete, as versatile as it has been, might become the prime material for construction....

Regolith Dynamics
Due to the differences of the gravitational accelerations of the Earth and Lunar environments, geotechnical engineering must be applied differently in the two environments. This study...

Combustion Synthesis of Advanced Materials
The combustion synthesis of ceramic-metal composites using an in-situ liquid infiltration technique is described. The effect of varying the reactants and their stoichiometry to provide...

Telerobotic Field Geologist: Preliminary Results of a Feasibility Study
We conducted three laboratory studies to explore the feasibility of developing a telerobot to perform planetary field geology. In all, 72 college students attempted to match each of 15...

Mars Via the Moon?A Robust Lunar Resources-Based Architecture
A space operations architecture is outlined that uses lunar materials to cost-effectively support Lunar and Mars exploration and operations. This architecture uses a chemically powered...

Utilization of On-Site Resources for Regenerative Life Support Systems at a Lunar Outpost
Regenerative Life Support Systems (RLSS) will be required to regenerate air, water, and wastes, and to produce food for human consumption during long-duration stays on the Moon. It may...

Very Low Frequency Radio Astronomy from Lunar Orbit
This paper discusses the use of very low frequency aperture synthesis as a probe of astrophysical phenomena. Specifically, the science achievable with the Lunar Observer Radio Astronomy...

Laboratory Evaluation of Footings for Lunar Telescopes
Presented here are the results of laboratory experiments with different footing shapes for lunar telescopes. These experiments used a variety of soils including some to simulate regolith...

Roof Management Alternatives for Aging Launch Infrastructure
This paper describes a Roof Management System approach to better cope with aging and deteriorating infrastructure support facilities at our national spaceports. It describes facility conditions...

Plot-scale Field Experiment of Surface Hydrologic Processes with EOS Implications
Plot-scale hydrologic field studies were initiated at NASA Marshall Space Flight Center to a) investigate the spatial and temporal variability of surface and subsurface hydrologic processes,...

Rocket Fuel to Earth Orbits from Near-Earth Asteroids and Comets
The analysis describes an architecture to bring 10,000 tons units of rocket fuel ore, propellant and construction mass back to low Earth orbit from newly discovered near-Earth comets or...

Metallized Microballoon EMI Shielding Materials
The number of applications requiring shielding against electro-magnetic interference (EMI) is growing. Materials that are lightweight, and formable need to be developed for shielding against...

In Situ Recovery of Water from Dormant Comet Cores & CI Carbonaceous Chondrites
Water and volatiles may be produced by drill holes into dormant comet cores or class CI or CM asteroids. This is modeled after in-situ mining as in the Frasch process sulfur mines of the...

Field Verification of a Wave-Induced Current Model
A unique data set of nearshore waves and current measurements over a bar-trough bathymetry was collected during a field experiment at Duck, NC, in October 1990. These high-quality data...

Model Development for Operational Use to Help Spill Combating and Sea Rescue
Based on twenty years' experience on flow velocity measurements, transport experiments and numerical modeling the three-dimensional (3D) models of water currents, transport and water quality...

 

 

 

 

Return to search