Voltage Versus Var/Power Factor Regulation on Hydro Generators
When paralleled to the utility bus, synchronous generators can be controlled using either terminal voltage or var/power factor regulation. Selection is dependent upon the size of the generator...
Influence of Surface Finish on Thrust Bearing Life
The original pivoted pad thrust bearing installed and fitted at the Holtwood Power Station in 1912 by A. Kingsbury has been operating continuously since that time without any difficulty....
Subsurface Savings
Less conservatism than usual in designing building foundations is being accepted or demanded by some owners to save money. The article describes four examples of cost-cutting innovations,...
Rennick Yard RCC Pavement Design and Construction
Rennick Yard roller compacted concrete paving project consisting of 136,000 multiplied by (times) yd**2 (113,710 m**2) was completed in June 1986. The design load for this project was...
Concurrent Nullspace Methods for Multibody Systems
This paper presents a new concurrent multiprocessing algorithm for simulating the dynamics of constrained multibody systems. The systems considered are quite general in nature; they may...
Parallel Algorithms for Structural Optimization Under Dynamic Loading
Parallel algorithms and strategies are outlined for optimal design of frame structures subjected to dynamic earthquake loading. Parallelism is extracted in six areas: substructuring of...
Shallow Foundation on Sand Underlain by Soft Clay with Geotextile Interface
One technique for improving the load-bearing capacity of shallow foundations on soft clay soil is to construct them over a compact granular fill laid over the clay layer. However, the...
Mining Subsidence Effects on Transportation Facilities
This paper presents case history information about mining subsidence effects on transportation facilities, including bridges, pavements, and culverts. Most of the field observations pertain...
Probabilistic Prediction of Pile Group Capacity
A reliability analysis of a group of free standing piles in clay is carried out using Monte Carlo simulation. The pile material strength, soil capacity, and the load on the pile group...
Modeling Fatigue Crack Growth Resistance, dN/da
In the fracture mechanics approach to fatigue, da/dN is correlated with the cyclic range of the stress intensity factor, ?K; the resulting relation, da/dN=f (?K), is commonly called the...
Load Combinations for Codified Design
Loading requirements used in current standards for structural design are not consistent in their conceptual basis, appearance or use. Unified limit states design procedures for structures...
Load-Sharing and Reliability of Wood Systems
A methodology for the study of reliability of light-frame wood structural systems is presented. Reliability levels associated with the bending strength limit state of such systems are...
Development of Bridge Design Code
Load and resistance parameters for bridges involve uncertainties due to natural randomness, imperfect models or human errors. Because of these uncertainties, absolute reliability is not...
Probabilistic Load Combinations in Nuclear Structures
A variety of loads affect a nuclear power facility during its lifetime. The magnitudes or intensities of these loads are uncertain, and for some of them, their time of occurrence is also...
A Reassessment of Codified Limit States Design
This paper examines the nature of design codes and their relation to engineering practice. It suggests that codes impose unjustifiable and, in the long term, destructive constraints on...
Markov Chains & Soil Constitutive Modeling
The focus of this research effort is the construction of a mathematical framework to assist in understanding the role of uncertainties in the constitutive/dynamic behavior of soils. The...
Pore Pressure Development: Probability Analysis
The development and subsequent dissipation of excess pore pressure, p in a soil deposit subject to an external load is examined using probability concepts that account for uncertainties...
Dependence of Fatigue Damage on Loading Amplitude Variability
Welded steel specimens have been tested under variable amplitude loadings to determine the extent to which fatigue life is affected by the rate of amplitude variability of the loading...
Fracture Control for Arctic Vessels and Structures
Materials used for construction of Arctic structures and vessels are exposed to low ambient temperatures, high local ice loads and intermediate to high loading rates. All these factors...
Upper-Bound Estimate of the Reliability of Plastic Slabs
This paper gives a brief presentation of some recent results on probabilistic analysis of plastic slabs, especially reinforced concrete slabs. The estimate of the reliability of such slabs...
Return to search