85 Stories in Kuala Lumpur?The 5th and 6th Tallest Buildings in the World
A concrete core and cylindrical concrete tube structure provides a safe, elegant, efficient and constructible solution to the challenge of designing the world's 5th and 6th tallest buildings,...
Tuned Mass Dampers for Towers and Buildings
Tuned mass dampers (TMD's) are used to reduce the response of tall slender structures to resonant wind-induced oscillations. This paper reviews the authors' experience with the design...
Structural Design and Wind Resistance of Fukuoka Tower with T.M.D.
Fukuoka Tower, which was built in 1989, was projected as a monument, a observation tower and a broadcasting antenna with 234m high. In this tower, a Tuned Mass Damper(TMD) was set, in...
Relationships with Architects and Owners
There are many issues which affect the relationships between structural engineers and on the other, the owner clients. This paper discusses some of those issues from the point of view...
Wind Hazards Reduction Program
The 1990's mark the International Decade for Natural Disaster Reduction. In this context, the Wind Effects Committee of the Structural Division strongly endorses the establishment of a...
Mitigation of Wind-Created Risks During Construction
Wind damage to structures during construction has been found to be significant and often catastrophic. Structural failures are often the result of wind loads that are far less than the...
Development of Computer-Based Models of Standards and Attendant Knowledge-Base and Procedural Systems
Existing and new technology can be used to develop a new generation of standards that would allow designers to use complex standards efficiently, help standard-writing bodies to detect...
Investigation of Full-Scale Performance of Structures?Research Potentials
It is well known that actual, or true, behavior of completed structures does not necessarily conform to often simplified analysis predictions. This may be due to any of several reasons...
Behavior of Horizontally Curved Steel Highway Bridges
Horizontally curved highway bridges represent up to 25 percent of the market for new steel-bridge construction each year. However, unanswered questions remain concerning the fundamental...
Bridge Management Research Needs
The present article deals with some aspects of bridge management of particular interest to bridge engineers and to bridge users at the moment. It addresses questions such as life-cycle...
Seismic Strengthening for Structures in Regions of Low Seismicity
Most existing structures were not designed to today's seismic codes and standards, and in fact in low seismicity regions codes did not require seismic design until recently....
Response of Concrete Filled Grid Decks Under Static Loads
This paper briefly discusses the bending strength and stiffness of concrete filled grid decks that are subjected to static loads. The influence of design parameters (traffic flow direction,...
Steel Alternates for the Hoover Dam Bridge
As input to the Environmental Impact Statement studies of appropriate long span bridges were performed for three alternate corridors across the Colorado River near Hoover Dam. Details...
Bridge Engineering and Life Cycle Cost
The Intermodal Surface Transportation Efficiency Act of 1991 (ISTEA) requires that all Federal Aid projects must 'consider...the use of life-cycle costs in the design and engineering of...
Reliability-Based Expert Systems for Optimal Maintenance of Concrete Bridges
In this paper ongoing research in the CEC supported BRITE/EURAM project P3091 is presented. In the project reliability based expert systems for inspection and maintenance of corroded reinforced...
An Information System on the Performance of Suspension Bridges Under Wind Loads
While most suspension bridges for which information is available, in operation between the period: 1701-1992, have performed satisfactorily under wind loads, a few bridges were destroyed,...
A Reduced Order Model for the Seismic Analysis of Building-Soil Systems
A finite element based, reduced order, numerical model has been developed for the nonlinear analysis of building-soil systems. The reduced order system model employs an equivalent continuum...
Recent Successes in Welding Jumbo Shapes
A rather unique structure utilizing jumbo shapes was recently designed and fabricated. The structure was 100% welded according to the specifications for welding jumbo shapes recently developed...
Simplified Reliability Analysis of Transmission Structures Including Both Geometric and Material Nonlinearities
Generally, in nonlinear structural systems, the g-functions of the components cannot be explicitly expressed in terms of the basic random variables. In using the design point method to...
Modal Failure Probability and System Performance
It is pointed out that the modal failure probability, i.e., the probability that a structure fails in a particular mode, cannot be uniquely defined under the time-invariant framework....
Return to search