Investigation of an Anisotropic k-? Model
In this paper the eddy viscosity hypothesis is abandoned and explicit expressions of Reynolds stress are deduced directly from the transport equations. Anisotropic k and ? equations are...
RCC For Seismic Design
Throughout its 70-year existence, the Littlerock Dam in Southern California's National Forest has been the subject of concern. Located only 1.5 mi south of the San Andreas...
The Engineer As Preservationist
Engineers in the U.S. have been involved in historic preservation at least since 1966, the year ASCE's Committee on the History and Heritage of Civil Engineering designated...
Stress Wave Loading of a Tunnel: A Benchmark Study
Five different finite element or discrete element computer codes were used to solve a sequence of problems leading to the problem of stress-wave loading of a circular tunnel in a jointed...
Design Wind Speed and Design Criteria of Buildings
Design load recommendations of Architectural Institute of Japan(A.I.J.) are revised according to a common principle to all kinds of loads. The basic wind speed is defined as the annual...
Vortex Shedding Induced Fatigue Fracture of Mast Tower
The fracture of a pair of 60m high circular steel masts is investigated. The design criteria and fabrication practices are reviewed. The cause of failure is related to the fatigued condition...
Fluid Viscous Damper for Improving the Earthquake Resistance of Buildings
Experimental results are presented which demonstrate that the use of fluid dampers as add-on devices in moment resisting frames substantially increases damping and reduces seismic story...
Investigation of Full-Scale Performance of Structures?Research Potentials
It is well known that actual, or true, behavior of completed structures does not necessarily conform to often simplified analysis predictions. This may be due to any of several reasons...
A Shear Transfer Model for Floor-To-Wall Connections in Concrete Masonry Structures
Based upon experiments conducted at the Univ of California, San Diego (UCSD) on floor-to-wall connections in concrete masonry structures, a constitutive model was developed for the overall...
Design of Connections in Wood Structures: LRFD vs. ASD
This paper provides a comparison of connection design capacities using load and resistance factor design (LRFD) procedures and allowable stress design (ASD) procedures....
Wood Diaphragm Design Capacities in LRFD Format
Wood diaphragms (horizontal and vertical) have performed well in resisting and transferring lateral forces imposed by major wind and seismic events. Resilient (ductile) behavior of wood...
Serviceability Reliability Analysis of Wood Beams
The effect of creep deformations on the serviceability reliability of single wood beams is investigated. Using stochastic load models and a time-dependent stress-strain relationship, the...
Flexural and Shear Behavior of Combined Concrete and Graphite Epoxy Beams
An experimental and analytical study of six graphite composite beams are presented. Four of the beams incorporated a reinforced concrete slab. The composite action and the effect of concrete...
In-Situ Determination of the Compressive Stress-Strain Relationship of Multi-Wythe Brick Masonry
In-situ stress-strain relationships of existing multi-wythe brick masonry have been determined by introducing flatjacks into sawcuts made in the exterior wythe of the multi-wythe masonry....
Interfacing Academia and the Practicing Profession
The paper presents a discussion of current topics and instructional methods in structural engineering in the United States. Following a review of typical subject matter in analysis and...
Bond Stress Test on Rock Anchor in Clayey Siltstone
Seventy five rock anchors with design loads of 556 to 2040 kips were required for the 1000-foot long, 125-foot high, concrete gravity, Lake Lynn Dam to comply with current FERC engineering...
Development and Evaluation of Remediation Strategies by Deformation Analysis
Deformation analysis is providing guidance for the most efficient and economical seismic remedial treatments for Mormon Island Auxiliary and Sardis dams. The computer program TARA-3FL...
Soil Nailing Technique in Tunnel Support
Authors have developed a new pre-lining method (PASS method) in which thin archshell lining is formed ahead of the tunnel face before the excavation to reinforce the ground. This method...
Investigation in 3-D of Stress Distribution in a Circular Tunnel and Vertical Emplacement Holes Due to Thermal and Overburden Loading in Tuff
Thermal stress and displacement analysis using two 3-D finite element models, one having a course mesh and one having a highly detailed mesh are presented. Results are compared to those...
Critical Stresses in Nuclear Waste Container Under Normal Handling Conditions
Critical stresses in the pintle, flat tophead, canister shell, the bottom plate and in the weldment of a high level nuclear waste canister are evaluated under a variety of static and dynamic...
Return to search