ASCE will be sunsetting the Civil Engineering Database (CEDB) in the coming months. We encourage you to start using the ASCE Library to perform content searches. In the ASCE Library, you can save your search results as well as receive email content alerts when new content relevant to your area of interest is published. Try it out today at https://ascelibrary.org.

 

Permeability of Compacted Clay Liners in Laboratory Scale Models
Experiments conducted in flexible wall permeameters have shown that the permeability of a soil sample is dependent on the size of the specimen tested. The permeability was found to decrease...

Quality Assurance Monitoring of a Large Clay Liner
The Keele Valley Landfill at Maple, Ontario, consists of a 99 ha (245 acre) facility to serve the Metropolitan Toronto area. The landfill is located in a former sand and gravel pit, with...

Bentonite Matting in Composite Lining Systems
The 1984 Hazardous and Solid Waste Amendments to RCRA mandated that double lining systems utilizing synthetic membrane liners be required for hazardous waste landfills. Recognizing the...

Engineering Aspects of Soil Erosion, Dispersive Clays and Loess
This collection of papers deals with selected engineering aspects of soil erosion, dispersive clays and loess. Two types of erosion are considered?surface and subsurface (piping)?with...

Consolidation of Slurried Soils
This paper describes the use of large strain consolidation theory and centrifugal modelling to study the consolidation behavior of slurries. Laboratory testing of the slurry is needed...

Models of Border Irrigation for Flat Clayey Soils
Border irrigation is widely used for irrigating pastures in south-east Australia. Inadequate earthworks, design and operation of irrigation layouts have been major causes of waterlogging...

Water Table and Salinity Movement in a Silty Clay Soil
The movement of the water table and profile salinity in a shallow drained soil in permanent pasture overlying an artesian aquifer was observed. Soil samples were taken before and after...

Geotechnical Practice for Waste Disposal '87
This volume contains 55 papers covering many aspects of geotechnical issues associated with waste disposal. The papers represent advances during the intervening decade since the first...

Sampling and Testing in Stiff Crustal Clays
In desiccated clays, the secondary structure consisting of fissures and slickensides greatly influence the measurement of soil strength. In a sampling study, such soils were found to be...

Mechanics of Crack Propagation in Stiff Clays
Many stiff clays forming part of natural slopes and earth dams exist in the fissured state. When these cracks are subjected to gravity induced normal and shear stresses they may propagate....

A Laboratory Investigation of the Undrained Small Strain Behavior of London Clay
Three different total stress-paths were followed during shearing of the anisotropic consolidated (CAU) tests: compression, extension and a stress-path simulating an element under a plate...

Lateral Pressure in a Stiff Clay
A series of consolidated undrained and drained triaxial tests and oedometer tests were performed on horizontal and vertical specimens taken from an overconsolidated cretaceous clay. An...

Excavation in Hard Clays of the Keuper Formation
For the construction of a lock on the Main-Danube-Canal in South Germany a 30 m deep cut had to be excavated in the overconsolidated clays and claystones of the Keuper formation. The strength...

Attapulgite: A Clay Liner Solution?
Poor performance of clay liners at waste management facilities has resulted in the EPA mandate of synthetic polymeric liner materials to comply with zero penetration requirements. Laboratory...

Reliability of Pile Capacity Assessment by CPT in Overconsolidated Clay
Correlations for unit skin friction and end bearing are established between cone penetration test (CPT) records, triaxial data and a small data base of measured skin friction and end bearing...

In Situ Tests with K_o Stepped Blade
The results of field tests conducted using the K//o Stepped Blade to determine lateral stresses and other geotechnical properties are presented. The sites tested represent a wide range...

The DMT - ?_hc Method for Piles Driven in Clay
This paper presents a tentative method for evaluating the limiting skin friction f//s for piles driven in clay based on sigma //h'c (horizontal effective stress at the interface...

Bearing Capacity of Footings on Clay CPT Method
A method is proposed to predict the ultimate bearing pressure for footings on clay using data from cone penetration tests. This method relates the ratio of ultimate soil bearing for a...

In Situ Measurement of Permeability in Soft Clays
As part of an extensive field programme, the magnitude of errors due to clay remoulding and filter clogging in tests performed in common piezometers is evidenced. Comparisons between variable...

Initial Results From an In-Situ Consolidometer
An In-Situ Consolidation Evaluation Device (ICED) was developed for field measurement of consolidation parameters by electro-osmosis. A brief description of the test apparatus and the...

 

 

 

 

Return to search