Scour in Non-Cohesive Beds at Culvert Outlets
An empirical relationship was developed to estimate the depth of scour in non-cohesive material at culvert outlets. The scour depth is expressed as a function of mean particle size of...
Maximum Scour Below Dams Caused by Over-Fall Flow
The scour of sediment below a check dam caused by over-fall flow will lead to the destruction of dams. The formation of the scour hole below the dam will lead to shorten the seepage lines,...
Bed Sediments and Bed Forms of the Lower Mississippi River
Approximately 500 bed material samples were collected from the thalweg of the Lower Mississippi River. At each sample location, a sonic record of the bed was obtained. From the appearance...
Characteristic Deformation of Alternate Bars Due to Low Flow
Experiments on the formation of a small meander-channel at low stage are conducted by supplying a proper discharge on initial bed of alternate bars that have been formed in experimental...
Sediment Concentration Measurements Below Small Headcuts
This study is designed to determine erosion rates downstream from a small headcut. The sediment concentration from a scour hole produced by a plunging jet is measured as a function of...
The Effect of Aeration on Scour
A vertical water jet was used to study the effects of entrained air, tailwater depth, size of bed material, jet diameter, and jet velocity on scour. Small amounts of entrained air were...
The Calculation of Flushing Flows for Gravel and Cobble Bed Rivers
Flushing flows are needed to remove fines and sand from a gravel or cobble bed river. A natural stream will have periodic high flows adequate for flushing of fines and sand, but the hydraulic...
River Sediment Discharge Study?San Diego Region
Procedures and general results are presented of a recent study performed to estimate the average annual sediment delivery (sand sizes and larger) from sources discharging to the southern...
Major Sedimentation Activities in the Soil Conservation Service
The Agricultural Research Service (ARS) and Soil Conservation Service (SCS) are cooperating in the development of tools to improve prediction of the magnitude of erosion processes, the...
Sediment and Aquatic Habitat Associations in River Systems
This paper results from the Task Committee's effort to summarize knowledge linking sediment transport and aquatic ecology. This paper presents one element of this work: the...
Sediment Transport, Hydraulic Retention Devices, and Aquatic Habitat in Sand-Bed Channels
Streams and rivers of all sizes and in all parts of the United States flow on sand-bed channels. Scour, Transport, and deposition of sediments particles are natural processes in these...
Delineation of Ordinary High Water
'Ordinary high water' is used in a court of law to delineate the extent of land ownership of adjacent riparian owners on navigable rivers. The most appropriate...
Sacramento's Proactive Stormwater Permit Program
In January 1990, with the encouragement and assistance of the California Regional Water Quality Control Board-Central Valley Region (Regional Board), the City and County of Sacramento,...
Slurry Removal From a 2-D Fluidized Region
A two-dimensional fluidization experiment is performed on fine sand with a 5.08 cm diameter source pipe with horizontally opposed orifices, 0.317 cm in diameter, spaced 5.08 cm. Slurry...
Landfill Liner Quality
Landfill liners are being made with new synthetic materials, materials which may be beyond the knowledge of the engineer in charge of the landfill construction project. Engineers need...
Advances in Pipeline Materials
Pipelines transport water, storm run-off, process wastes, petroleum, natural gas, slurries, solids, sewage, steam and other fluids either by gravity or under pressure. Pipelines are also...
Selection of Hole Size for Fluidization Pipes
Two-dimensional fluidization experiments are performed on fine and medium coarse quartz sands at depths of 25.4 and 42 cm. Four supply pipes are used with orifice diameters of 1.587 mm...
U.S. Construction Aggregates
Crushed stone and sand and gravel are the two main sources of natural construction aggregates in the United States as well as in the world. At the beginning of the 20th century, the production...
Model for Nonlinear Behavior of Bolted Joints Under Bending/Tension Loading
A mathematical model to predict the load-deformation relationship of single-bolted connections in wood structures subjected to bending/tension loading is described. The model accounts...
Influence of Epoxy Coating on Stress Transfer from Steel to Concrete
To assess the influence of epoxy coating on the bond characteristics of reinforcing bars, a series of tests was conducted to determine differences in stress transfer between coated and...
Return to search