Orthotropic Rigidities of Curved Concrete Waffle Slabs
Analytical expressions are derived for predicting the flexural and torsional rigidities during the pre-cracking and post-cracking stages for horizontally- curved waffle slab structures....

Blast-Damaged Concrete Structures in Beirut
This paper describes the effect of blasting loads on structural members. It identifies predominant structural systems in war-damaged zones of Beirut and to explain typical damage mechanisms....

Steel Plate Energy Absorbers for Improved Earthquake Resistance
This paper discusses results of an combined experimental and analytical investigation on seismic response of frame structures using welded steel triangular plates as added damping and...

Fluid Viscous Damper for Improving the Earthquake Resistance of Buildings
Experimental results are presented which demonstrate that the use of fluid dampers as add-on devices in moment resisting frames substantially increases damping and reduces seismic story...

Seismic Base Isolation Design for the San Bernardino County Medical Center Replacement Project
The SBCMC Replacement Project, located in Colton, California, consists of six separate building structures containing a total of approximately 86,000 m2...

Neural Networks in Structural Control
Let the response of a simple two-story frame to a stochastic dynamic excitation be controlled by activating suitable actuators. A neural network is trained to recognize, from the measurement...

Joint Design in Composite Columns/Steel Beam Structures
The use of a composite building system, utilizing a composite exterior column and a concrete spandrel beam system, proposed by Dr. Fazlur Khan in 1967, is recalled. In the last 25 years,...

Correction Factor Method for Building Analysis Under Sequential Dead Loads
The effect of the sequential application of dead load due to the sequential nature of construction is an important factor to be considered in the multistory frame analysis. One of the...

Composite Beams and Joists
Composite beams and joists used as flexural members in multistory steel-frame buildings are considered. Research results have shown that present design values for headed shear studs, used...

Effects of Earthquake Intensities and Site Conditions on the Reliability of RC Frame Structures
This paper evaluates the effects of seismic zone factors and site coefficients on the seismic reliability of reinforced concrete frame structures. A nine-story intermediate moment-resisting...

Mapping Structural Damage to Monetary Damage
Earthquake damage estimation/prediction is still an area which requires expertise and judgment of the experts in the field. Making the predictions/estimates more accurate is an area of...

Full-Scale Testing of Unreinforced Masonry Infill Frame Panels
This paper presents the results of the out-of-plane testing phase of the National Science Foundation Grant BCS 9102347. This phase of the program addresses the out-of-plane response to...

Built-Up Compression Members for Noval Structural Systems
This paper discusses built-up compression members used in novel structural systems for two high-rise buildings: InterFirst Plaza at Dallas Main Center and Columbus Center in New York....

How to Optimize Steel Frameworks
This paper presents the details of a design synthesis strategy to conduct computer-automated design of least-weight structural steel frameworks, where members are automatically sized using...

Properties in Sensitivity Coefficients of Framed Structures
This paper presents a special relationship among sensitivity coefficients of static response, natural frequency and mode. The relationship is that the sum of sensitivity coefficients in...

A Simulation of the Quake-response on the Frame with Large Basement-box under the Earthquake from Deep Soil Layer
This paper treats a study of computing vibratory analysis and its comparison with measurements for the earthquake-responses on an actual 19 storied pure frame-structure with its height...

User Identified Short-Term and Long-Term Needs for Pavement Management Innovation
A survey involving 300 practicing engineer's from all over the United States and representing 20 other countries was conducted, concerning ideas and opinions of the priority research needed...

Vitalization Policy of Local Region by Port Space Utilization
The present paper investigates policies of decayed local regions by port space utilization in Japan and proposes a new frame to manage risks in order to lead them to success. It contains...

Composite Beams: Redistribution, Reliability, and Lateral Buckling
Research relevant to three aspects of the design of composite beams for ultimate limit states is summarized. These are: the redistribution in continuous beams and in framed structures...

Composite Space Frame?Experimental/Analytical Study
This paper describes work carried out on a composite space frame system. The system, previously developed for roof construction, comprised a pyramidal arrangement of steel angles and circular...

 

 

 

 

Return to search