Minnesota Road Research Project - An Overview
The Minnesota Department of Transportation in cooperation with the Federal Highway Administration and the Local Roads Research Board of Minnesota is constructing the Minnesota Road Research...
Visco-elasticity and the Compressive Failure of Polycrystalline Ice
The analysis of the visco-elasticity of polycrystalline ice is addressed. Experimental results on isotropic and anisotropic polycrystalline ice are presented, which indicate that intracrystalline...
Anelastic Straining in Polycrystalline Ice
This paper presents experimental observations on the influence of stress, grain size and total strain level on the magnitude of anelastic strain in granular freshwater ice. Cyclic loading...
Microstructure and Mechanical Behaviour of Ice
Short descriptions are given for ice in nature, test methods used to evaluate their deformation behaviour and, a general microstructure-based constitutive equation. Equations suitable...
Fractal Crushing
This paper develops an approach to a two-dimensional fragmentation process, in which floating ice floes are driven against each other and break up into smaller floes. It first considers...
Effect of Grain Size Variation on Damage in Polycrystalline Ice
This paper studies the effect of grain size distributions on damage accumulation in polycrystalline ice under uniaxial compression. The numerical results are derived from the internal-variable...
The Ductile-Brittle Transition in Ice & Size Effect
This paper considers the ductile to brittle transition in ice under compression. Two criteria, one phenomenological and the other more physical, are presented for the transition strain...
Fracture Resistance to Cracking in Ice: Initiation and Growth
The issue of notch sensitivity and brittleness of the test failure is used to forecast the necessary specimen size for a material property initiation toughness; a methodology is developed...
Size Effects in the Fracture of Quasi-Brittle Materials
Causes and influences of the structural size effect that is exhibited by materials such as concrete, mortar, ice rock and ceramics, are discussed. The size effect law, which models this...
Laboratory Observations of Macroscopic Failure Modes in Freshwater Ice
A review is presented of tests performed in the laboratory by several investigators on indentation in freshwater ice. A number of the observed failure modes are discussed. From the results,...
Effective Pressures Measured During Indentation Tests in Freshwater Ice
Indentation tests were conducted by pushing flat, vertical indentors of two different widths (50 and 100 mm) against the edges of floating, freshwater ice at different velocities (0.6-150...
Snow Fence Operational and Material Testing
The proliferation of snow fence products since the late 1970's presents an opportunity for optimizing the control of drifting snow. It also presents a challenge in discriminating...
Earth Walls: Making the Right Choice
Earth walls are retaining walls where the ground assumes a load-bearing role. These walls either support compacted earth (embankment-type reinforced compacted earth walls such as Doublewal...
Design of Large Capacity Coal Silos for Service Life
Design and construction of Large Capacity Coal Silos for service life requires a careful consideration of the silo configuration as well as the material handling system. This paper presents...
Improved Corrosion Protection for Flue Gas Systems Utilizing a Dual Liner Concept
A unique system of corrosion resistant materials has shown excellent performance and durability in flue gas systems for fossil plants, cogeneration plants, waste incinerators and waste-to-energy...
Designing for Corrosion Control
This presentation will discuss designing from several aspects: a. Designing of the item to lessen the affects of corrosion. b. Selection of non-corrosive materials in the designing process...
Containment Capacity and Failure Modes Beyond Design Basis Conditions
Analytical and experimental studies have shown that containments can at least sustain two to three times design pressures. Under the severe accident overpressure loading, experimental...
Fly Ash Grouts for Subsidence Control
A laboratory investigation was undertaken to examine procedures for evaluating candidate grouts and to develop quality grouts for use in abandoned mines. The objective of this grout application...
Properties and Environmental Impact of Stabilized Fly Ash
This paper summarizes the results of two research studies aimed at evaluating the properties and possible environmental effects of bituminous and lignite coal based fly ashes stabilized...
Stabilized Fly Ash Cover for a Municipal Waste Landfill
The study reported herein and several recently related projects have been aimed at reducing the hydraulic conductivity of fly ash and physiochemically fixing any potential leachable metals....
Return to search