Low-Land Hydraulics and Hydrodynamics
A hydrodynamic model is presented for simulation of wetland hydrodynamics. The model incorporates all elements of the hydrologic cycle, such as precipitation, runoff, groundwater seepage...
Two Case Studies of Stochastic Identification of Aquifer Hydraulic Parameters and Natural Recharge
A method to identify aquifer transmissivity, storativity and natural recharge (inverse modeling), based on a geostatistical approach is presented. The basic assumptions of the method are...
Seven Oaks Dam Outlet Works Design
The U.S. Army Corps of Engineers has completed the preliminary design of the outlet works for the proposed Seven Oaks Dam. The dam is the upstream-most feature of the Corps'...
Sediment Ramping at Mill Creek
A Corps of Engineers study completed in 1988 analyzed this ramping phenomenon Mill Creek in Southern California Using an approach which combined sedimentation research with Corps experience...
Lower Santa Ana River Hydraulic Design for Levee Overtopping
The purpose of overtopping or freeboard design is to minimize damages and catastrophic failure from floodwaters overtopping levees. This case study is presented to show the approach taken...
Scale Effects at Intakes Due to Boundary Layer Growth
Boundary layer development in hydraulic models of intakes based on Froude criteria can be poorly scaled because it is viscosity dependent. The potential for scale effects can be estimated...
Physical Modeling of Heated Discharges into a Stagnant River
An alternative cooling system study was performed for the Damietta Combined Cycle Plant in Egypt. The alternatives included spray canals, helper cooling tower and once-through cooling....
Model Study of New Madrid Pumping Station
The proposed pumping station on the New Madrid Floodway consisted of a draft tube type sump design (referred to as a formed suction inlet) to eliminate swirl and provide a more uniform...
Hydraulic Analysis of the Schoharie Creek Bridge
Ten people died on April 5, 1987 as a result of the collapse of two spans of a New York State Thruway bridge into the floodwaters of Schoharie Creek. The cause of the bridge failure was...
Two-Dimensional Inter-Rill Flow Model for the Analysis of Agricultural Runoff
This paper presents a model describing the flow field for the inter-rill component of agricultural runoff. Given rainfall intensity, surface roughness, rill spacing, and longitudinal and...
Overfall Stress and Pressure Distributions
The magnitude and distribution of hydraulic shear stress and pressure on the boundary of a straight drop overfall are presented for multiple overfall heights and flow rates. Hydraulic...
Jet Injection Model Studies for the City of Los Angeles
The Hypersion Treatment Plant for the City of Los Angeles is currently undergoing an expansion project. A major component of this system is a sludge recycling system. And it is essential...
Energy Dissipation Structure for Fixed-Cone Valves
Results of a model study to investigate the hydraulic performance of a proposed energy dissipation structure for fixed-cone valves are presented. Procedures for estimating pressures and...
Prediction of Siltation at a Point
This paper describes a zero-dimensional mathematical model which predicts siltation at a point on a cohesive sediment bed. The processes of erosion, deposition and consolidation are modelled...
High-Resolution Two Dimensional Advective Transport
The paper describes a two-dimensional high-resolution scheme for advective transport that is based on a Eulerian-Lagrangian method with a flux limiter. The scheme is applied to the problem...
Hydraulic Design Aspects of the Boston Outfall
The diffuser outfall under design for Boston must have the ability to be purged of seawater upon commissioning or following an accidental flow stoppage. The criteria governing the flushing...
A Rational Approach to Selecting an Optimal Design Storm for Flood Control
A rational methodology is presented herein for determining the optimal design storm frequency when planning for flood protection in new urban areas. The technique was developed from an...
Design and Performance of Diversion Gates at Peace Canyon Dam
During construction of Peace Canyon Dam, river diversion was accomplished using a combination of cofferdams and temporary diversion conduits through the partially completed dam. Inlet...
Physical Modeling of Major Cutoffs
In 1987, a model study of Lock and Dam No.4 on the Red River in Louisiana required two major cutoffs and a lock and dam to be modeled. Although the Waterways Experiment Station has modeled...
Probabilistic Approaches to Maintenance
All structures and their components are subject to the aging process, to wear and tear in the performance of assigned functions and to deterioration by exposure to the operating environment....
Return to search