Corrosion Fatigue of Deepwater Offshore Materials
Evaluation of the fatigue life of offshore structures operating in depths of up to 10,000 feet (3,048 m) requires knowledge of the combined effect of axial and hydrostatic loading on the...
Effects of Freezing on Impact Properties of RTM Composites, and Their Applications in Offshore Structures
Resin transfer molding is rapidly being acknowledged as the process with potential to create perhaps the purest form of a composite material as representative of the concept of `material-by-design.'...
Fiber Ropes for Ocean Engineering in the 21st Century
Recent advances in synthetic fiber ropes will greatly influence the practice of civil engineering in the oceans during the 21st Century. New fibers have moduli almost as high as steel...
Composites for Offshore Applications: A Multidisciplinary Education Program for the Marine Industry
Composites are increasingly being considered for offshore and other marine structural applications. Polymeric matrix composites reinforced with glass, carbon, and aramids offer substantial...
Use of X-Ray Computed Tomography in the Study of Marine Sediments
X-ray computed tomography (CT scanning) is primarily a medical imaging technique. When applied to marine sediments, it responds predominately to the spatial density distribution within...
Utilization of Waste Materials in Civil Engineering Construction
Industrial growth has increased the volume of wastes generated from energy production, mining, industrial processes and civil works. For economic and related reasons, the use of waste...
Put to the Test
In the construction industry, the concept of life-cycle cost applies not only to the infrastructure itself, but to the materials that go in to building that infrastructure. To improve...
Pressure Pipeline Design for Water and Wastewater
This committee report,
Cellular Sheet-Pile Floodwall
Williamson, W. Va., flooded 37 times in this century, will soon be guarded by a $41 million, 4000 ft floodwall being built by the U.S. Army Corps of Engineers. A series of 41 circular...
Laboratory Methods for Preparing Low-Density Frozen Saline Soil Samples
Laboratory methods were developed for preparing low-density frozen saline soil samples with density values ranging from 85-110 lb/ft3. This range...
The Effect of Loading Rate on the Bending Strength of Alluvium Reinforced Ice
Traditional building materials are often less than ideal for construction in remote Arctic locations. Their mechanical properties may be degraded in extreme cold, and costs associated...
Sludge Dewatering in Freezing Beds
This paper summarizes the results of laboratory and pilot scale studies on the development of the sludge freezing bed. Laboratory studies indicated that a freezing bed could dewater up...
Numerical Analysis of Frost Shields
The term 'frost sheilding' has been used to describe the practice of using flat stock rigid insulation materials burial above a water or sewer pipe to reduce...
New Admixtures for Cold Weather Concreting
Chemicals were tested for their ability to promote strength gain in portland cement concrete at low temperature. The admixtures depressed the freezing point of the mix water and accelerated...
High-Performance Concrete in All-Weather Deck Pours
A high-performance concrete mix enhanced with a combination of microsilica, superplasticizer, and high dosages of an corrosion-inhibiting, accelerating admixture (calcium nitrite); proved...
Minnesota Road Research Project - An Overview
The Minnesota Department of Transportation in cooperation with the Federal Highway Administration and the Local Roads Research Board of Minnesota is constructing the Minnesota Road Research...
Visco-elasticity and the Compressive Failure of Polycrystalline Ice
The analysis of the visco-elasticity of polycrystalline ice is addressed. Experimental results on isotropic and anisotropic polycrystalline ice are presented, which indicate that intracrystalline...
Anelastic Straining in Polycrystalline Ice
This paper presents experimental observations on the influence of stress, grain size and total strain level on the magnitude of anelastic strain in granular freshwater ice. Cyclic loading...
Microstructure and Mechanical Behaviour of Ice
Short descriptions are given for ice in nature, test methods used to evaluate their deformation behaviour and, a general microstructure-based constitutive equation. Equations suitable...
Fractal Crushing
This paper develops an approach to a two-dimensional fragmentation process, in which floating ice floes are driven against each other and break up into smaller floes. It first considers...
Return to search