Use of Long, Variable Length Steel Fibres in Shotcrete
Steel wires are cut to fibres in a shotcrete nozzle and directly incorporated in the ejected shotcrete. Long and variable length fibres can be used. The fibre material is better utilized...

Steel Fibre Reinforced Wet Shotcrete with Very High Deformation Capacity
Tests have been carried out under site conditions in Norway where the performance of 40 mm long DRAMIX fibres was compared with normally used 30 mm fibres. The fibres were mixed into the...

Various Techniques for Fiber Reinforcement
Placing wire netting in thin shotcrete layers was found to be a difficult, dangerous and time-wasting method. Searching for other ways to reinforce the concrete, it has been found that...

Advances in Shotcrete Technology for Support of Underground Openings in Canada
This paper presents a broad overview of the state-of-the-art of shotcrete technology for support of underground openings in Canada. Advances in shotcrete technology such as the introduction...

Construction of Shotcrete Linings Channel Tunnel
Without the use of shotcrete and the flexibility it offers in terms of tunnel profile, economy and speed of tunnelling, the project would certainly not be as far advanced as it is at present....

Fibre Reinforced Shotcrete Case Studies of Wet and Dry Processes
Both wet shotcrete and fibre reinforced shotcrete are being increasingly utilised in the South African mining industry. This Paper describes two applications of fibre reinforced shotcrete...

A Review of Sprayed Concrete Linings Adopted at Dinorwig Power Station
Sprayed concrete was adopted extensively as one element of both temporary and permanent rock support during the construction of the 1800 MW Dinorwig underground power station in North...

Reinforced Shotcrete Linings as Part of an Integrated Support System Used in a High Stress Mining Environment
Shabanie and King Mines are situated in the Southern part of Zimbabwe, some 60 km apart and approximately 200 km east of Bulawayo. They are the largest underground operations in Zimbabwe...

A Microcomputer Model to Estimate the Benefits of Volume Generated Auxiliary Passing Lanes on Two-Lane, Two-Way Highways
Safety and operational characteristics of rural and suburban two-lane roadways can be substantially improved by the provision of adequate passing opportunity, especially as traffic volumes...

Determining Hours of Congestion for Urban Freeways
The concept of Hours of Freeway Congestion is a measure of effectiveness in the evaluation of freeway reconstruction scenarios. The procedure described herein estimates future traffic...

Computer Applications on the Central Artery/Tunnel Project
Boston's Central Artery/Tunnel (CA/T) project consists of the reconstruction of a 4.2 mile segment of Interstate Route 93 in downtown Boston, a 3.3 mile extension of Interstate Route 90...

Tutorial on Computer-Aided Design
These tutorial sessions are designed to provide a basic introduction to the use of Computer-Aided Design/Drafting (CAD) in transportation engineering, with particular regard to Civil Engineering...

Technical Evaluations Necessary for Determining Site Suitability for a High-Level Waste Repository
Congress, under the Nuclear Waste Policy Act of 1982, as amended, has charged the Department of Energy with the responsibility for safely and permanently disposing of high-level radioactive...

Factors Controlling Strong Ground Motion and Their Associated Uncertainties
Of special interest in strong ground motion modeling is a quantification of the degree of influence specific physical parameters have on the computed motions. Associated with the model...

Scoping the Monitoring Instrumentation to Meet Repository Design and Construction Needs
This paper discusses categories of instruments that are available and recommended for consideration to monitor the engineering performance and interactions of the geologic media, groundwater,...

ASTM C666 (A) Freeze-Thaw Durability of Air-Entrained Wet- and Dry-Mix Shotcrete
In order to assess the freeze-thaw durability of shotcrete, six samples of dry-mix shotcrete and one sample of wet-mix shotcrete were mixed outdoors at Hydro-Quebec's research institute...

Engineering: Environmental vs. Developmental Goals
The 1992 winner of the Daniel W. Mead Student Paper competition explores the potential conflict for engineers, between environmental and developmental goals. Noting a dictionary definition...

Safety Enhancement of Bridges with Seismic Isolation Bearings
This paper summarizes the experimental and analytical studies done at Dept. of Civil Eng., Kyoto Univ., on application of base isolation bearings to highway bridges and the Menshin (base...

Data Base for Seismis Rick Assessment in Mexico City
We describe a model to estimate expected ground motions and expected damage, based on intensity damage relations derived for 14 classes of buildings representative of Mexico City construction....

Earthquake Resistant Design and Construction of Reinforced Concrete Buildings. The Practice in Mexico After 1985
The evolution of the design and construction practice of reinforced concrete buildings in Mexico is presented in terms of materials, structural systems, member design and reinforcement...

 

 

 

 

Return to search