Effect of Water Depth and Groundwater Table on Infiltration from Recharge Basins
The actual effect of water depth on infiltration depends on the depth to groundwater and on whether the wetted perimeter of the basin is clean or covered by a clogging layer of fine particles...
Design of Steel Transmission Pole Structures
The Bearing Capacity of Debris Flows
Debris flows are made of a cohesive muddy matrix in which large and heavy particles exist in suspension. To explain how these particles are maintained in suspension, several mechanisms...
Unsteady Flow of Bingham Viscoplastic Material in an Open Channel
An analytic solution for transient flow of a Bingham viscoplastic material in an open channel is presented. The solution for the response to a time-varying pressure gradient predicts shear...
Predicting Stream Width and Bank Retreat
The width of streams is dependent on the flood flow discharge which varies from year to year, the bank material which varies from stream to stream and reach to reach, the sediment load...
Resistance Consisting of Both Viscous Force and Dispersive Force
A set of specially designed experiments have been carried for studying the resistance of a flow consisting of water and both fine and coarse particles. The viscous force caused by fine...
Sediment Transport Characteristics of Hyperconcentrated Flow with Suspended Load
In this paper, based on the analysis of the ovserved data, a set of theories is proposed of the transport of heper-concentrated sediment, the basic points of which are: (1) The hyperconcentrated...
Stable Channel Analytical Design Method
The Flood-Control Channels Research Program is being conducted at the US Army Engineer Waterways Experiment Station to develop systematic methods for design of stable channels for small...
Can Erosion Control Meet Regulatory Standards?
An erosion control design method for rainfall/surface erosion is presented that enables the designer to determine design loads and the resulting erosion control requirements. Design loads...
The Method of Lines Solution of Unsteady Open Channel Flow Equations Along Characteristics
The method of characteristics (MOC) has long been considered as a natural procedure for solving transient flow problems. In this paper, by using the concept of the method of lines, the...
Hydraulic Modeling of Flow Control Gates
Flow control gates are subject to complex hydrodymanic loadings, which may in many cases only be predicted through investigation on a physical hydraulic model. Scaling of gate models,...
Advances in Pipeline Materials
Pipelines transport water, storm run-off, process wastes, petroleum, natural gas, slurries, solids, sewage, steam and other fluids either by gravity or under pressure. Pipelines are also...
Wood Variability Effects in Structural Assessment
Engineers evaluating the load carrying capacities of in-service wood structures commonly determine the strength and stiffness properties of structural wood members by various assessment...
Bond Performance of Reinforcing Bars Embedded in Fiber Reinforced Concrete and Subjected to Monotonic and Cyclic Loads
The primary variables investigated were fiber content and loading history. The reinforcing bar size was ASTM #5. Steel fibers with hooked ends were used with four fiber contents, namely;...
Rate Effects on Fracture of Concrete
An analytical and experimental investigation of mode I (tensile and mixed mode (combined tensile and shear) fracture of concrete subjected to impact loading was conducted. The rate of...
Creep of Polycrystalline Ice
This paper discusses the extension of creep models for polycrystalline ice to include the effects of a non-monotonic loading history. Attention is focussed on cyclic loading since it is...
Repair of an Improperly Detailed Masonry Facade: A Case History
The masonry facade of an 18-story condominium building was constructed with an inconsistent pattern of shelf angle supports, marginal lateral restraints and without any horizontal control...
Durability of Fly Ash Concrete in the Marine Environment
This paper presents the experimental investigation of durability of air-entrained fly ash concrete in the marine environment. The findings indicate that the deterioration rate of durability...
Effect of Fly Ash on the Microstructure and Durability of Concrete
The influence of fly ash on the microstructure and durability of concrete was investigated. It was found that the use of 50% fly ash in concrete reduced greatly its resistance to freezing-and-thawing...
Permeability Effects on the Sulfate Resistance of Concrete
A laboratory study was conducted to determine the effect of permeability on the sulfate resistance of concrete containing fly ash. Concrete specimens were moist cured for 7 and 100 days...
Return to search